Almacenamiento; Troubleshooting - Homelite UT08084 Manual Del Operador

STORAGE (1 month or longer)
1. Drain all fuel from tank into a container approved
for gasoline. Run engine until it stops.
2. Clean all foreign material from the blower. Store
it in a well-ventilated place that is inaccessible
to children. Keep away from corrosive agents
such as garden chemicals and de-icing salts.
3. Abide by all Federal and local regulations for the
safe storage and handling of gasoline. Excess
fuel should be used in other 2-cycle engine
powered equipment.
TROUBLE SHOOTING
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICING DEALER.
Problem
Engine will not start:
Engine starts but will not accelerate:
Engine starts but will only run at high speed at half
choke:
Engine does not reach full speed and emits
excessive smoke:
Engine starts, runs, and accelerates but will not
idle:
A
REMISAGE -
(1 mois ou plus) (1 mois ou plus) (1 mois ou plus) (1 mois ou plus) (1 mois ou plus)
1. Vidanger complètement le réservoir de carburant
dans un récipient agréé pour contenir de
l'essence. Faire tourner le moteur jusqu'à ce
qu'il s'arrête.
2. Éliminer tous les objets étrangers du souffleur.
Remiser l'appareil dans un local bien ventilé
inaccessible aux enfants. Tenir l'appareil à l'écart
des produits corrosifs (produits chimiques de
jardinage, sel, etc.).
3. Respecter toutes les réglementations fédérales
et locales relatives au stockage et à la
manipulation de l'essence en toute sécurité. Le
carburant en surplus sera utilisé dans un autre
équipement à moteur 2 temps.
Possible Cause
1. No spark.
2. No fuel.
3. Flooded engine.
4. Starter rope pulls harder now than when new.
Carburetor requires adjustment.
Carburetor requires adjustment.
1. Check oil fuel mixture.
2. Air filter dirty.
3. Carburetor requires adjustment.
4. Spark arrestor screen dirty.
Carburetor requires adjustment.
Note: This engine complies with EPA (Environmental Protection Agency) and
*
CARB (California Air Resource Board) regulations which require exhaust
emission control. As a result, the carburetor adjustment needle(s) are equipped
with plastic cap(s) that limit the rotation from the original factory adjustment. If
your unit exhibits specific performance problem(s) where the Trouble Shooting
Section recommends a needle adjustment and you are at the limit of adjustment,
the unit should be taken to a factory authorized service center for repair.
B
ALMACENAMIENTO - (1 mes o

ALMACENAMIENTO

ALMACENAMIENTO (1 mes o (1 mes o (1 mes o
ALMACENAMIENTO ALMACENAMIENTO (1 mes o
más) más) más)
más) más)
1. Drene toda la gasolina del depósito en un
recipiente homologado para uso con gasolina.
Ponga en marcha el motor hasta que se pare.
2. Limpie todos los materiales extraños que haya
en la soplador. Almacénela en un lugar bien
ventilado que se encuentre fuera del alcance de
los niños. Manténgala alejada de agentes
corrosivos tales como productos químicos para
el jardín o sales descongelantes.
3. Cumpla con todas los reglamentos nacionales
y locales que se apliquen al almacenamiento y
al manejo de la gasolina. El combustible sobrante
debería ser utilizado en otro equipo que tenga
un motor de 2 tiempos.
Solution
1. Check spark. Remove spark plug. Reattach
the spark plug cap and lay spark plug on
metal cylinder. Pull the starter rope and watch
for spark at spark plug tip. If there is no spark,
repeat test with a new spark plug.
2. Push primer bulb until bulb until fuel is visible
in the bulb. If fuel is not apparent, the primary
fuel delivery system is blocked. Contact a
servicing dealer. If primer bulb fills, engine
may be flooded (see next item).
3. Remove spark plug, turn trimmer so spark
plug hole is aimed at the ground. Move choke
lever to "RUN" and pull starter cord 10 to 15
times. This will clear excess fuel from engine.
Clean and reinstall spark plug. Pull starter
three times with choke lever at "RUN". If
engine does not start, move choke lever to
"CHOKE" and repeat normal starting proce-
dure. If engine still fails to start, repeat proce-
dure with a new spark plug.
4. Contact a servicing dealer.
Contact a servicing dealer.
*Turn mixture needle (A) counterclockwise
1/16 turn.
1. Use fresh fuel and the correct 2-cycle oil
mix.
2. Clean per instructions in Maintenance Sec-
tion.
3. *Turn mixture needle (A) clockise 1/16 turn.
4. Contact a servicing dealer.
Turn idle speed screw (B) clockwise to in-
crease idle speed.
11