Polygroup SUMMER WAVES El Manual Del Propietario página 10

6. Connect the Short Tubes
4
See NOTE below.
4 4
NOTE:
Refer to the part list on page 7 for the exact
quantity of Short Tubes
total quantity to form the horizontal beams on
the short sides of the pool.
8. Rotate the short and long tubes to align the holes in the tubes
with the openings on the sleeves.
Swedged End
5
• Align the holes of 4 and 5
with the sleeve openings.
10. Insert the U-Shaped Pipes
the pool.
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.
10
.
. Connect half the
4
• Make sure all the swedged ends of
are pointing to the clockwise direction.
Swedged End
4
into the straps at the bottom of
2
2
2
MST. Extended operating days and hours during peak season requirements.
7. Carefully slide the connected Short Tubes
into the sleeves on the short sides of the pool.
Swedged End
4
4 and 5
9. Connect the Corner Pieces
Corners. You should have a closed rectangular pool frame;
which is the frame around the top of the pool.
NOTE: The Corner Pieces
spring pins. THIS IS NORMAL. Only the Long and Short Tubes
& have holes to catch the spring pins.
4 5
3
x4
11. Continue to insert all of the U-Shaped Pipes
as shown below.
2
2
2
2
2
4
4
to the tubes at each of the 4
3
DO NOT have holes to catch the
3
3
3
3
2
2
2
2
2
2