Polygroup SUMMER WAVES El Manual Del Propietario página 11

12. Insert the ends of the U-Shaped Pipes
look like the image on the right below. You are now ready to add your filtration system. DO NOT add water until the filter system is installed.
IMPORTANT: BEFORE ADDING WATER TO YOUR POOL YOU MUST INSTALL THE
**POOL WALL FITTINGS OR ***ENTIRE FILTRATION SYSTEM FIRST.
BEFORE ADDING WATER TO YOUR POOL FOLLOW THE INSTRUCTIONS BELOW.
**IMPORTANT: FOR POOLS THAT DO NOT COME WITH A FILTRATION SYSTEM
**IF YOUR POOL INCLUDED OPENINGS AND POOL WALL FITTINGS ONLY; YOU MUST INSTALL THOSE, THE WATER CAP
AND THE SERVICE PLUG BEFORE PUTTING ANY WATER IN YOUR POOL. PLEASE FOLLOW THE DIRECTIONS BELOW.
**If your pool included openings or if you are going to purchase a filter pump system, position the Suction & Return fitting locations so they are 10 to 21 feet from
the electrical outlet you plan to use for the pool pump.
**If your pool came with Fittings - Install both the Suction and Return fittings to the pool wall before filling the pool. Please Note: The Black Rubber gasket (#1 or
#5) should always be slid over the threaded plastic suction or return fitting and be on the inside before the fitting is placed through the pool wall to make a
watertight connection.
Make sure to Put on both the Water cap and the Service Plug before filling your pool with water and leave them in place until you are ready to add a filtration
system.
Inside Pool Wall
Outside Pool Wall
SUCTION FITTING
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.
into the frame around the top of the pool as shown below. The final frame and liner assembly should
2
Water cap
Inside Pool Wall
MST. Extended operating days and hours during peak season requirements.
OWNER'S MANUAL
Outside
Pool Wall
RETURN FITTING
Service Plug
SNAP ON
RETURN
FITTING
OR
THREADED
TYPE
RETURN
FITTING
11