***IMPORTANT: FOR POOLS THAT INCLUDE A COMPLETE FILTRATION SYSTEM
***IF YOUR POOL INCLUDES A COMPLETE FILTRATION SYSTEM WE RECOMMEND THAT YOU COMPLETELY INSTALL THE
ENTIRE FILTRATION SYSTEM FIRST BEFORE PUTTING ANY WATER IN YOUR POOL TO AVOID WATER LOSS.
***FOLLOW THE "SETUP INSTRUCTIONS" IN THE FILTER PUMP SYSTEM OWNER'S MANUAL TO INSTALL THE POWER FILTER
SYSTEM, THE POOL WALL FITTING(S) AND ALL HOSES AND CLAMPS BEFORE PUTTING ANY WATER IN YOUR POOL.
13.
Make sure the liner drain fitting is plugged securely and the cap is in place. Then start filling the pool with water until about 1-inch of
water is on the bottom.
AFTER ABOUT 1-INCH OF WATER IS ON THE BOTTOM, STOP FILLING AND COMPLETELY SMOOTH OUT ALL THE WRINKLES
FROM ON THE BOTTOM OF THE POOL, WORKING FROM THE CENTER OUTWARD. MAKE SURE THE FLOOR OF THE POOL IS
COMPLETELY FLAT SO THAT THE POOL FILLS EVENLY
IMPORTANT:
IF MORE THAN 1-2 INCHES OF WATER COLLECTS ON ANY ONE SIDE BEFORE THE POOL STARTS FILLING IN
THE CENTER, THE POOL IS NOT LEVEL ENOUGH, AND MUST BE CORRECTED.
ADDITIONAL NOTE: THE WEIGHT OF THE WATER WILL PREVENT ADJUSTMENT AFTER THIS POINT.
NOT FOLLOWING THE STEP ABOVE WILL MAKE THE POOL FILL UNEVENLY AND THE POOL MAY LEAN TO ONE SIDE AND
COLLAPSE. THE WATER IN YOUR POOL SHOULD FILL EVENLY. IF YOUR POOL IS LEANING AT ALL; THE GROUND MAY NOT
BE LEVEL AND YOU WILL NEED TO START OVER.
• FAILURE TO FOLLOW THE INSTRUCTIONS ABOVE WILL CAUSE POOL TO COLLAPSE AND WILL VOID THE WARRANTY!
14. When the water is approximately half filled, the top frame will tend to bend down at the middle as shown below.
Continue to fill with water up to the fill line printed on the inside of the liner wall., the frame will restore to its normal shape.
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.
12
THIS IS ABSOLUTELY NORMAL.
MST. Extended operating days and hours during peak season requirements.