Setup; Operation; Trouble; Cleaning And Maintenance - marklin 44738 Manual De Instrucciones

from the USB power source and the 4x4 Mobile
Power Plus STAX.

5. Setup

see setup, page 29-33

6. Operation

Operating the Power STAX & light modes
The six different modes of Light STAX can be acti-
vated by pressing the button of the Power STAX.
Press the button to cycle through the various
settings. The default setting is permanent on.
1. The button turns GREEN. All Light STAX Building
Blocks connected to the Power STAX stay
permanent on.
2. The button turns YELLOW. All Light STAX
Building Blocks connected to the Power STAX
start to light up with Sound Activator picking up
sounds.
3. The button turns BLUE. All Light STAX Building
Blocks connected to the Power STAX start
flashing.
4. The button turns RED. All connected Light STAX
building blocks light up in a heartbeat rhythm.
5. The button turns LIGHT BLUE. All Light STAX
Building Blocks connected to the Power STAX
will gently fade off and on.
6 The button turns VIOLET. All connected Light
STAX building blocks light up from the sound-
dependent sound activation (clapping) and
remain on for about 10 seconds. The Light
STAX light building blocks then flash briefly four
times. After that, the Mobile Power STAX Plus
goes into Stand-By mode and is ready for the
next sound activation.
Operating the Record STAX
Voices, sounds of any kind, or even music can be
recorded for more than 60 seconds with Record
STAX.
Indicator
8
Speaker
Button
Recorder
Playback of Record STAX Recording in an End-
less Loop
1. Turn the Mobile Power STAX Plus on in the
Permanent Mode (GREEN logo button). The
INDICATOR lights up briefly as soon as Record
STAX is supplied with current and then swit-
ches off again to save current.
2. Press the button once on Record STAX to start
the playback of the Record STAX recording.
3. As you come out of the endless loop playback
mode, press the button twice on Record STAX
to turn off Record STAX.
Recording with Record STAX
Note: The previous recording is overwritten!
1. Turn the Mobile Power STAX Plus on in the
Permanent Mode (GREEN logo button). The
INDICATOR lights up briefly as soon as Record
STAX is supplied with current and then swit-
ches off again to save current.
2. Press and hold down the button on STAX. The
recording starts when you hear the „peep".
3. The recording is ended by releasing the button
on Record STAX.
4. The maximum recording time is about 80
seconds. A double „peep" confirms the end of
the recording.

7. Trouble

Vibration or standing for long periods can loosen
individual building blocks. This causes individual
Light STAX light building blocks to no longer light
up. The building blocks must be pressed on each
other again firmly in order to fix this.

8. Cleaning and Maintenance

Never allow the Light STAX light building blocks,
the Mobile Power STAX Plus, and the Record
STAX to be exposed to water! Just wipe with a
clean, damp cloth.
Recharge the battery no later than 6 months after
not being used in order to avoid deep discharge.
Deep discharges damage the battery, reduce the
performance, and shorten the possible operating
time.