Disposal Considerations; Declaration Od Conformity - Klarstein 10028129 Manual Del Usuario

Problem
Ice cube is very thin
Ice cube is too thick.
"FULL" indicator is on
Ice making cycle is
normal, but there is
no ice cube produced.
Error Indicator
E1 Ambient temp sensor breakdown.
E2 Suction tube temp sensor.
E3 Both Ambient temp sensor and Suction tube temp sensor breakdown.
FULL Magnetic control switch cutoff - "Full" light will be on when plugging on or just turning
on the unit. And it will delete the breakdown display if this switch is electric shorted.
E4
The duration time of one ice making cycle is more than 35 minutes. The unit will be
turned off. It is the system protection of no refrigerant in cooling system or the com-
pressor not work.
ADD "ADD WATER" light is on, maybe caused by the lower main water supply pressure or
WATER clogging of the water supply hose During the water supplying process, it takes more
than 6 minutes, but the water level detecting switch also can not be connected, then
the light will be on and means absence of the water.
According to the European waste regulation 2002/96/EC this symbol on the product
or on its packaging indicates that this product may not be treated as household was-
te. Instead it should be taken to the appropriate collection point for the recycling of
electrical and electronic equipment. By ensuring this product is disposed of correct-
ly, you will help prevent potential negative consequences for the environment and
human health, which could otherwise be caused by inappropriate waste handling of
this product. For more detailled information about recycling of this product, please
contact your local council or your household waste disposial service.
Producer: CHAL-TEC Vertriebs- + Handels GmbH, Wallstraße 16, 10179 Berlin.
This product is conform to the following European Directives:
2009/643/EC (ErP)
2004/108/EC (EMC)
2011/65/EU (RoHS)
2006/95/EC (LVD)
21
Possible Cause
Ambient temperature is too
high.
Air circulation around the
unit is not good.
Ambient temperature is too
low.
The ice storage bin is full of
the ice cube.
The temperature of Ambi-
ent, or water in water tank
is too high
Refrigerant leakage.
Cooling system tube is
clogged.

Disposal Considerations

Declaration of Conformity
Solution
Move the unit to low temperature space, or
lengthen the time of each ice making cycle.
Make sure there is more than 20CM space be-
tween the unit back & front and the obstacle.
Reduce the time of each ice making cycle.
Take out some ice cube.
Move to the place with temperature lower
than 32 centigrade, and change to the low
temperature water.
Need the technical serviceman to maintain.
Need the technical service person to main-
tain.