Cleaning Extremely Dirty Floors; Using The Steam And Steam Plus Models - Duplex STANDARD 340 Instrucciones Para El Uso Y Mantenimiento

DUPLEX 340-420-620
1.11

CLEANING EXTREMELY DIRTY FLOORS

When it is necessary to thoroughly wash floors with ingrained dirt it is advisable to prevent
detergent solution recovery.
In such condition the water left on the floor will serve to further soften the dirt and this will be
subsequently removed by an energetic brushing action together with the steam.
To deactivate the recovery device, proceed as follows:
1. Stop the machine (if in operation);
2.
Position the MOP-UP lever (figure "1.10") upwards.
Then, by positioning the MOP-UP lever downwards the automatic dirty water recovery system
will be re-activated.
IMPORTANT!
This procedure is not advised for carpets or rugs.

USING THE STEAM AND STEAM PLUS MODELS

1. Press the main switch on the boiler (A) (figure "1.16").
The switch will light up, and after approximately
1 minute, the boiler will reach the operating
temperature.
2. Press the steam switch (1) located on the handle. The
machine will begin to spray steam in a continuous
manner.
3. Operate the lever positioned under the handle every
time that floor needs additional wetting.
4. Slowly lower the handle on one of the sides. The
machine will start up and the revolving brushes will
start revolving on the floor.
5. Move the machine forwards following the same washing
track.
6. Dispense the liquid by activating the lever underneath the
handle at brief intervals and only when the machine is moving
forwards, taking care not to flood the floor.
62
A
Figure 1.16
1
Figure 1.17