Hardware Connections - Zyxel ZyWALL 70 Manual Del Usuario

1 Hardware Connections

1.1 Front Panel and Connections
LABEL
RESET You only need to use this button if you've forgotten the ZyWALL's password. It returns
the ZyWALL to the factory defaults (password is 1234, LAN IP address 192.168.1.1,
terminal emulation settings as described below etc.; see your User's Guide for details).
LAN Connect a computer to this port with an Ethernet cable. This port is auto-negotiating (can
connect at 10 or 100Mbps) and auto-crossover (automatically adjust to straight-through
or crossover Ethernet cable).
WAN-1/2 Connect your cable/DSL modem to this port with the cable that came with your modem.
DMZ 10/100M Connect publicly accessible servers (Web, FTP, etc.) to these ports to make them visible
to the outside world. Use Ethernet cables to connect these ports to computers or
switches.
DIAL BACKUP Only connect this port if you want to set up a backup WAN connection; see your User's
Guide for details.
Connect the 9-pin female end of your modem or TA (Terminal Adaptor) cable to this port
and the other end to your modem or TA.
CONSOLE Only connect this port if you want to configure the ZyWALL using the SMT (System
Management Terminal) via console port; see your User's Guide for details.
Connect the 9-pin male end of the console cable to the console port of the ZyWALL and
the other end to a serial port (COM1, COM2 or other COM port) on your computer. Your
computer should have a terminal emulation communications program (such as
HyperTerminal) set to VT100 terminal emulation, no parity, 8 data bits, 1 stop bit, no flow
control and 9600 bps port speed.
ZyWALL 70 Internet Security Appliance
3
DESCRIPTION