Features And Controls; Know Your Generator - Craftsman 580.326310 Instrucciones De Uso

KNOW YOUR GENERATOR

Read the Operator's Manual and safety rules before operating your generator.
Compare the illustrations with your generator to familiarize yourself with the locations of various controls
and adjustments. Save this manual for future reference.
120 Volt AC, 20 Amp
Duplex Receptacles
120/240 Volt AC,
30 Amp Receptacle
Circuit Breakers (AC)
Double Pole Circuit
Breaker (AC)
120 Volt AC, 20 Amp, Duplex Receptacles — May be
used to supply electrical power for the operation of 120 Volt
AC, 20 Amp, single phase, 60 Hz electrical, lighting,
appliance, tool and motor loads.
120/240 Volt AC, 30 Amp Locking Receptacle — May be
used to supply electrical power for the operation of
120 and/or 240 Volt AC, 30 Amp, single phase, 60 Hz
electrical, lighting, appliance, tool and motor loads.
Air Cleaner — Protects engine by filtering dust and debris
out of intake air.
Battery Float Charger Jack — Use battery float charger to
keep the starting battery charged and ready for use.
Choke Lever — Used when starting a cold engine.
Circuit Breakers (AC) — Push to reset circuit breakers are
provided to protect the 120 VAC, 20A duplex receptacles
against electrical overload.
Data Tag — Provides model, revision and serial number of
generator. Please have these readily available when calling
for assistance.

FEATURES AND CONTROLS

Fuel Tank
StatStation™
Grounding
Fastener
Data Tag
Air Cleaner
Recoil Starter
Choke Lever
Double Pole Circuit Breaker (AC) — A double pole circuit
breaker is provided to protect all the receptacles and
generator against electrical overload.
Engine Rocker Switch — Set this switch to "On" before
starting engine. Set switch to "Off" to stop engine.
Fuel Tank — Capacity of seven (7) U.S. gallons.
Grounding Fastener — Consult your local agency having
jurisdiction for grounding requirements in your area.
Oil Fill Cap — Check and fill engine with oil here. See page
16 for oil recommendations and filling instructions.
Recoil Starter — Used to start the engine.
Spark Arrester Muffler — Exhaust muffler lowers engine
noise and is equipped with a spark arrester screen.
Start Switch — Push and hold in "Start" position for a
maximum of 15 seconds during each start attempt, until
engine starts.
StatStation™ — Displays the nominal load on generator
based on output frequency. It also has a built in
maintenance reminder.
5
Spark Arrester Muffler
Battery Float
Start Switch
Charger Jack
Engine
Rocker Switch
Oil Fill Cap