Installation; Notes On Installation - Dometic GROUP WAECO CoolAir RT880 Instrucciones De Instalación

CoolAir RT880, SP950T
6

Installation

A
NOTICE!
The air conditioning roof unit may only be installed by qualified person-
nel from a specialist company. The following information is intended for
technicians who are familiar with the guidelines and safety precautions
to be applied.
6.1

Notes on installation

These installation instructions must be read completely prior to the instal-
lation of the air conditioning roof unit.
The following tips and instructions must be observed wile installing the air
conditioning roof unit:
!
WARNING!
Make sure that all electrical components are electrically discharged
before carrying out work on them!
 Always check whether any vehicle components could be damaged or
their operation impaired by the unit before installing the air condition-
ing roof unit. You can use fig. 1, page 3 and fig. 2, page 3 to check
the dimensions of the installed unit. The dotted line indicates the mid-
dle of the sunroof opening.
 Before installation, find out (by consulting the manufacturer of the
vehicle) whether the construction is designed for the static weight and
the loads of the parking cooler when the vehicle is in motion. The
manufacturer of the air conditioning roof unit assumes no liability
whatsoever.
 The roof inclination of the mounting surface may not exceed 8° in the
direction of travel.
 The supplied assembly parts must not be modified during installation.
 The ventilation slots (grill) may not be covered (minimum distance
from other attachment parts: 10 cm).
 You can connect the unit to the battery via the lorry's terminal block or
directly. The direct connection to the battery is preferred. On some
vehicles, larger consumers connected to the terminal block are
switched off after a short while if the power requirement is too high.
Ask your vehicle manufacturer for the specifications of the terminal
block.
 When installing the system and making the electrical connections,
observe the guidelines from the body manufacturer.
EN
Installation
39