Preparing The Unit (Rt880 Only); Attaching The Seal For The Cab Roof; Installing The Unit In The Sunroof - Dometic GROUP WAECO CoolAir RT880 Instrucciones De Instalación

Installation
6.2.2

Preparing the unit (RT880 only)

A
NOTICE!
During preparatory work on the surfaces, secure the unit from falling
down.
Make sure that the work surface is clean and level to ensure that the unit
is not damaged.
➤ Place the air conditioning roof unit on a work surface with the housing
facing down.
A
NOTICE!
Screw in the thread insert vertically.
Do not exceed the screw torque of 10 Nm.
➤ Screw in the 8 self-threading M8 thread inserts in the blind holes
marked with "1" (fig. 3 1, page 4).
Use the supplied 1/4" bit for this.
6.2.3

Attaching the seal for the cab roof

A
NOTICE!
Ensure that the adhesive surface for the seal between the unit and the
cab roof is clean (free of dust, oil, etc.).
➤ Stick the 2.5 m insulating tape (10 x 20 mm) to the cab roof, following
the outline of the sunroof opening (fig. 4, page 4).
➤ Provide the abutting edge and the top edge of the insulating tape with
an unhardened plastic butyl sealing compound (e.g.
SikaLastomer-710).
6.2.4

Installing the unit in the sunroof

➤ Drill out the existing holes (fig. 5 10, page 5) on the roof opening to
∅ 10 mm.
➤ Deburr the drill holes.
➤ Protect the drill holes from corrosion.
➤ Set the unit down centrally aligned and in the direction of travel
(fig. 1, page 3) on the sunroof opening.
42
CoolAir RT880, SP950T
EN