Installing The Electrical Supply Lines - Dometic GROUP WAECO CoolAir RT880 Instrucciones De Instalación

CoolAir RT880, SP950T
I
NOTE
Make sure the air conditioning roof unit is centred perfectly. The seal
must be applied continuously around the air conditioning roof unit after
being placed on the roof of the vehicle. This is the only way to ensure a
tight seal.
➤ Place the spacer sleeve L = 18 mm (fig. 5 1, page 5) and (SP950T
only) the washer 8.4 x 16 (fig. 5 8, page 5) on the fastening drill
holes as shown in fig. 5, page 5.
➤ Screw one hex screw M8 x 40 mm (fig. 5 4, page 5) with a washer
(fig. 5 2, page 5) and spring washer (fig. 5 3, page 5) in the
8 thread inserts on the bottom of the unit.
A
NOTICE!
Do not exceed the specified torque under any circumstances. This is the
only way to ensure that the thread inserts are not torn out.
➤ Tighten the screws with a torque of 8 Nm.
6.2.5

Installing the electrical supply lines

!
WARNING!
 The electrical power supply may only be performed by qualified
personnel with specialist knowledge.
 Make sure there is no voltage present on electrically operated
components before carrying out work on them!
A
NOTICE!
 Fit a fuse of 30 amps to the connection to the vehicle's power supply.
 The battery must be able to supply the required current and voltage
(chapter "Technical data" on page 50).
I
NOTE
The unit is equipped as standard with a 11 m long cable with a cross-
section of 8 mm
You can connect the unit to the battery via the lorry's terminal block or
directly. The direct connection to the battery is preferred. Ask your vehicle
manufacturer for the specifications of the terminal block.
For connecting to the battery, proceed as follows:
➤ Plug the connection cable into the socket of the parking cooler supply
line.
➤ Secure the connection cable with a cable tie, e.g. to the cab roof.
EN
2
.
Installation
43