Descargar Imprimir esta página

Evolution R255SMS-DB Instrucciones Originales página 10

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 78
Where it is necessary to use spacer or reducing
rings these must be suitable for the intended
purpose and only as recommended by
the manufacturer.
If the mitre saw is fitted with a laser it shall not
be replaced with a different type. If the laser fails
to operate it shall be repaired or replaced by the
manufacturer or authorised agent.
The saw blade shall only be replaced as detailed in
this instruction manual.
Never attempt to retrieve off-cuts or any other part
of the work-piece until the cutting head is in the
raised position, the guard is fully closed and the saw
blade has stopped rotating.
WARNING: Only check the operation of the blade
guarding system with the machine disconnected
from the power supply. To check blade guard
operation: Raise and lower the Cutting Head
several times and visually check the operation of the
retractable blade guard.
Note: The retractable blade guard should exhibit
no signs of judder but smoothly draw into the upper
blade guard as the Cutting Head is lowered. As the
Cutting Head is returned to the upper position, the
blade guard should emerge from the upper blade
guard to fully enclose the machines blade.
• Ensure that in the full upper position the
Cutting Head is locked in place by the Blade
Guard.
PERFORM CUTS
(3.8)
CORRECTLY & SAFELY
Wherever practicable always secure the
work-piece to the saw table using the work clamp
where provided.
Always ensure that before each cut the mitre saw is
mounted in a stable position.
If needed the mitre saw can be mounted on
a wooden base or work bench or attached to
a mitre saw stand as detailed in this instruction
manual. Long work-pieces should be supported
on the work supports provided or on appropriate
additional work supports.
WARNING: The operation of any mitre saw
(2.8)
can result in foreign objects being thrown
towards your eyes, which could result in severe
eye damage. Before beginning power tool
operation, always wear safety goggles or safety
glasses with side shield or a full face shield
when needed.
www.evolutionpowertools.com
WARNING: If any parts are missing, do not
operate your mitre saw until the missing parts
are replaced. Failure to follow this rule could
result in serious personal injury.
ADDITIONAL SAFETY ADVICE
(3.9)
CARRYING YOUR MITRE SAW
WARNING: When using electric tools basic safety
precautions should always be followed to reduce
the risk of fire, electric shock and personal injury
including the following.
READ all these instructions before attempting to
operate this product and save these instructions.
Safety Advice:
• Although compact, this mitre saw is heavy.
To reduce the risk of back injury, get competent
help whenever you have to lift the saw.
• Hold the tool close to your body when lifting.
Bending your knees so you can lift with your
legs, not your back. Lift by using the cutting
handle on the head of the mitre saw and
the large, orange handle on the rear of the
carriage slide.
• Never carry the mitre saw by the power cord.
Carrying the mitre saw by the power cord could
cause damage to the insulation or the wire
connections resulting in electric shock or fire.
• Before moving the mitre saw tighten the
mitre and bevel locking screws and the sliding
carriage locking screw to guard against sudden
unexpected movement.
• Lock the cutting head in its lowest position.
Ensure that the cutting head locking pin is
completely engaged in its socket.
WARNING: Do not use the blade guard as a
'lifting point' . The power cord must be removed
from the power supply before attempting to
move the machine.
• Lock the cutting head in the down position using
the cutting head locking pin.
• Loosen the Mitre Angle locking screw. Turn the
table to either of its maximum settings.
• Lock the table in position using the
locking screw.
• Wrap the cable around the cable guide.
10

Publicidad

loading