DeVilbiss CARLISLE SRiPro Lite Micro Manual De Mantenimiento página 10

Depending on hose length, larger I.D. hose may be required. Install an air gauge at the gun handle.
When gun is triggered on, adjust regulated pressure as required. Do not use more pressure than is
necessary to atomize the material being applied. Excess pressure will create additional overspray and
If quick connect couplings are required, use only high flow quick connects. Other types will not flow
SPRAY GUN MAINTENANCE & CLEANING
To clean air cap and fluid tip, brush exterior with a stiff bristle brush. If necessary to clean cap holes,
use a broom straw or toothpick if possible. If a wire or hard instrument is used, extreme care must
be taken to prevent scratching or burring of the holes which will cause a distorted spray pattern.
To clean fluid passages, remove excess material, then flush with gun wash solution. Wipe the gun
exterior with a dampened cloth. Never completely immerse in any solvent or cleaning solutions as
this is detrimental to the lubricants and life of the spray gun.
SPRAY GUN DISASSEMBLY / ASSEMBLY
#
#
SB-2-512 R1
NOTE
reduce transfer efficiency.
NOTE
enough air for correct gun operation.
Order for disassembly
- see over page
(reverse for assembly)
(reverse for assembly)
- see over page
10/24
KEY
EN
www.carlisleft.com