Carrera 655 Manual De Instrucciones página 36

You may interrupt and/or continue the programme at any time using
● ●
START/STOP H
During the programme sequence you may add further ingredients by re-
● ●
moving the dosing cap and adding the ingredients through the opening.
If you accidentally open the lid with the safety closure in this situation, the
● ●
programme will be interrupted automatically whilst CLOSE will be flashing
on the display, requesting you to reattach the lid properly.
Upon completion of programmes
● ●
gramme will be activated automatically.
At the end of the cooking programmes, a signal will sound 5 times and the
● ●
display will show the 20 min. of time for the heat retention programme as
well as the current temperature.
If no programme is selected within 10 minutes after completion of the
● ●
automatisms, the appliance will automatically switch off.
Programme M – Manual mode
Manually defining the temperature, duration and blending speed
Time setting from 1–60 minutes.
● ●
Speed setting from 7.000–20.000 (in 4 steps): 7.000, 10.000, 15.000 and
● ●
20.000 (display without rpm).
Temperature setting in 3 steps: OFF, 80 and 100 degrees (display without °C).
● ●
1. "M" (manual mode)
the SET button L
2. The time digits are flashing; use the control knob to select the time; the
control knob is held and the time increased/reduced; press the SET button.
3. The speed digits are flashing; use the control knob to set the speed;
press the SET button.
4. The temperature digits are flashing; use the control knob to set the tempera-
ture; press the SET button. Start or correct.
5. "Change programme mode" is active again; press the SET button again;
manual settings can be made as previously.
6. Press the START/STOP button
set time has expired. Press the START/STOP button again if you would like to
abort the process.
7. The cooking process stops with a sound signal (5x) and automatically
switches to the heat retention mode (20 minutes).
NOTES:
When using the manual mode, the interval between mixing and cooking must
be selected according to the TEMP setting (the higher the temperature, the
34 GB
.
A
D
D
is selected using the control knob;
lights up; press the SET button.
H
; the blender starts and stops as soon as the
and B , the heat retention pro-