Modifying The Motor Rotation Direction - SOMFY Sonesse 28 WireFree RTS Li-ion Manual De Instrucciones

EN
Observations
Setting is not
allowed. The drive
moves briefly 3
times in one direction
and 3 times in the
other direction
Red LED blinks 3
times and 3 times
intermittently.
Red LED blinks
slowly for 3 seconds
before and after
motor running.
2.4.2. End limit readjustment
Attention
Control point must be paired to the driven product.
Orange LED blinks slowly until the new end limit is recorded.
2.4.2.1. Readjusting the upper end limit
1) Briefly press the UP button, to move the driven product to
the upper end limit.
2) Press and hold the UP and DOWN buttons simultaneously
until the driven product briefly moves Up and Down.
3) Press and hold the UP or DOWN button to move the driven
product to the new desired position.
4) To confirm the new position press and hold the MY button
until the driven product briefly moves Up and Down and
green LED blinks 5 times.
2.4.2.2. Readjusting the lower end limit
1) Briefly press the DOWN button to move the driven product
to the lower end limit.
2) Press and hold the UP and DOWN buttons simultaneously
until the driven product briefly moves Up and Down.
3) Press and hold the UP or DOWN button to move the driven
product to the new desired position.
4) To confirm the new position press and hold the MY button
until the driven product moves Up and Down and green LED
blinks 5 times.

2.4.3. Modifying the motor rotation direction

1) Using the UP or DOWN button on the control point, move
the driven product away from the end limits.
2) Press and hold the UP and DOWN buttons simultaneously
until the driven product briefly moves Up and Down and
orange LED starts to blink slowly.
3) Press the MY button until the driven product briefly moves
Up and Down to reverse the rotation direction and green
LED blinks 5 times.
4) Press the UP button to check the new rotation direction. The motor rotation direction is reversed.
6
Possible causes
Maximum number of control points
reached.
Maximum/minimum value of the
setting is reached.
End limits are too close
Battery is low. Battery capacity is
less than or equal to 5%.
Copyright 2017 - 2019 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
©
Sonesse 28 WireFree RTS / Sonesse ULTRA 30 WireFree RTS
Solutions
Erase control points from memory
referring to add a new control point
2.4.5. Erasing control points from
memory
Perform correct setting.
Readjust the end limits referring
to chapter 2.4.2. End limit
readjustment
Charge the battery.
1
3
1
3
1
3
2
4
2
4
2
4