KOBE IN-02 Serie Instrucciones De Instalación Y Manual De Operación página 9

Wiring to Power Supply
SAFETY WARNING
RISK OF ELECTRICAL SHOCK. THIS RANGE HOOD MUST
BE PROPERLY GROUNDED. MAKE SURE THIS IS DONE
BY QUALIFIED ELECTRICIAN IN ACCORDANCE WITH ALL
APPLICABLE NATIONAL
CODES. BEFORE CONNECTING WIRES, SWITCH POWER
OFF AT SERVICE PANEL AND LOCK SERVICE PANEL TO
PREVENT POWER
ACCIDENTALLY.
10. Temporarily wire the hood to test for proper operation
before installing. If the insert does not operate, check
the circuit breaker or house fuse. If the insert is still not
working, disconnect the power supply and check the
continuity of all wiring connections.
11. Connect electrical wires.
12. Connect three wires (black, white and green) to house
wires and cap with wire connectors.
according to their colors (i.e. black to black, white to
white, and green to green). See Figure 4.
13. Store wires in the wiring box.
Note: Connect all electrical wires before installing insert.
DO NOT turn on the power until installation is complete.
Duct Work Installation
Hood Preparation Before Installation
CAUTION
: If moving the cooking range is necessary
to install the hood, turn off the power in an electric range at
the main electrical box.
MOVING A GAS RANGE.
16. Determine and mark the centerlines on the base of the
wood frame where the insert will be installed.
17. Determine and make all necessary cuts in the wall or
ceiling for the ductwork.
before installing the insert.
18. Cut out the opening where the insert will be installed.
(Figure 6)
AND LOCAL
FROM BEING SWITCHED
SHUT OFF THE GAS BEFORE
Note: Install the duct work
Figure 4
ELECTRICAL
ON
Figure 5
Connect wires
Figure 6
7