Atlantis OnePower Sx80 Manual De Instrucciones página 30

LED Information
Main
Press the UPS On/OFF [
Switch
the Buzzer sounds twice, the UPS will be start-up.
To enable "DC-Start" Function when Utility fails. (To enable DC
[ ]
Start properly, you are recommended to connect <80% output
load with the UPS only). P.S. Make sure the computer connected to
the UPS is switched on before enable the "DC-Start" function. You
are not recommended to add some other computer or peripherals
after DC-Start function is activated.
1 Line mode.
2 Battery mode. buzzer alarms (every 2 seconds), every seconds
when UPS is in battery low condition.
3 AVR mode
4 Battery capacity.
5 Load level.
6 Measurement Target & Value (Input AC, Output AC, Input VDC).
7 Remains standstill when UPS is fault.
] Switch for approx. 3 seconds, then
30
ENG