Commissioning Settings; Date And Time; Language; Set Degrees - monolith EXTRA Manual Del Usuario

COMMISSIONING SETTINGS

Once the power cable at the back of the generator has been connected, move the switch, also located on the back, to (I).
The switch at the back of the generator powers the generator board.
The generator remains o and a rst screen appears on the panel reading OFF.
LINE FREQUENCY 50/ 60HZ
If the generator is installed in a country with a frequency of 60Hz, the generator will display "incorrect line frequency". In this case, adjust the
frequency to 60Hz.

DATE AND TIME

This menu allows the date and time to be set.
To set: OK > SETTINGS > DATE /TIME.

LANGUAGE

This menu allows the preferred language to be selected.
To set: OK > SETTINGS > LANGUAGE.

SET DEGREES

This menu allows to set the desired unit of measurement.
To set: OK > SETTINGS >SET DEGREES
DO NOT USE ANY TYPE OF FLAMMABLE LIQUIDS FOR IGNITION!
DO NOT ALLOW THE BAG OF PELLETS TO COME INTO CONTACT WITH THE BOILING HOT STOVE DURING THE
FILLING PHASE!
IN THE EVENT OF CONTINUED FAILURE TO LIGHT, CONTACT AN AUTHORISED TECHNICIAN.
NO IGNITION
THE APPLIANCE MAY FAIL TO LIGHT BECAUSE THE AUGER IS EMPTY AND NOT ALWAYS ABLE TO LOAD THE BURN POT
WITH THE NECESSARY QUANTITY OF PELLETS IN TIME TO REGULARLY IGNITE THE FLAME.
IF THE PROBLEM OCCURS AFTER ONLY A FEW MONTHS OF OPERATION, CHECK THAT THE ROUTINE CLEANING
DESCRIBED IN THE STOVE BOOKLET HAS BEEN CARRIED OUT CORRECTLY.
IT IS FORBIDDEN TO USE THE DEVICE WITHOUT A PARTITION/RESISTOR A
AND PELLET SLIDE ASSEMBLY B .
REMOVAL WILL COMPROMISE THE SAFETY OF THE PRODUCT AND RESULT IN
THE IMMEDIATE NULLIFICATION OF THE WARRANTY PERIOD.
IN THE EVENT OF WEAR OR DETERIORATION, REQUEST THE PART'S
REPLACEMENT FROM THE AFTER SALES SERVICE.
REPLACEMENT DOES NOT FALL WITHIN THE PRODUCT WARRANTY AS THE
PART IS SUBJECT TO WEAR .
ENGLISH
B
A
71