Set; Power; Room Temperature; Ventilation - monolith EXTRA Manual Del Usuario

SET

POWER

The menu allows the generator power to be set Minimum power 1, maximum power 5.
To set: OK > SET > POWER.

ROOM TEMPERATURE

The menu allows to set the room temperature to reach. (front ventilation must be active). Range:
LOW TA 07 40 HOT
To set: OK > SET > ROOM TEMP..

VENTILATION

This menu allows to enable or disable the operation of the motor and to adjust the fan speed.
To set: OK > SET > VENTILATION.

EASY SETUP

The volumetric weight of the pellet is the ratio between the weight and the volume of the pellet.
This ratio may change while keeping the quality of the pellet unchanged. By using the EASY SETUP
function, it is possible to change the calibration of the volumetric weight by increasing or decreasing
the pre-set values.
In the stove program, the available values go from "– 3" to "+ 3"; all stoves are calibrated during
production with the optimal value which is 0
If you notice an excessive deposit on the burning pot, access the EASY SETUP program and lower the value of one unit to "- 1"; then wait until
the next day and if there is no improvement, decrease again, to a maximum of "- 3". Instead, if it is required to increase the calibration of the
volumetric weight of the pellet, go from the factory value "0" to "+ 1, + 2, + 3" as required.
To set: OK > SET > EASY SETUP.
EXCESSIVE DEPOSIT OF PELLET IN THE BURNING POT
-3 -2
SECOND
THIRD DECREASE
DECREASE
RANGE IF THE
RANGE IF THE
FIRST TWO ARE
FIRST IS NOT
NOT ENOUGH
ENOUGH
N.B.: If these settings do not solve the deposits of pellets present in the burning pot, please contact the service centre of your area.

NORMAL OPERATION

-1
FIRST DECREASE
OPTIMAL FACTORY
RANGE (TEST FOR
VALUE
1 DAY)
ENGLISH
LITTLE DEPOSIT OF PELLET IN THE BURNING POT
0 +1
FIRST INCREASE
RANGE
+2 +3
SECOND THIRD INCREASE
INCREASE RANGE RANGE IF THE
IF THE FIRST IS FIRST TWO ARE
NOT ENOUGH NOT ENOUGH
73