Cleaning And Maintenance; Maintenance; Periodic Cleaning Under User'S Responsibility - monolith EXTRA Manual Del Usuario

CLEANING AND MAINTENANCE

FOLLOW THE INSTRUCTIONS ALWAYS IN COMPLETE SAFETY!
Š Make sure that the power cord is unplugged because the generator may have been programmed to turn on.
Š That the generator is cold all over.
Š The ashes are completely cold.
Š Ensure e cient air exchange in the room during the product cleaning operations.
Š Poor cleaning will compromise correct operation and safety!

MAINTENANCE

For correct operation, the generator must undergo routine maintenance by a quali ed technician, at least once a year.
The periodic inspection and maintenance operations must always be performed by specialised, quali ed technicians, who operate in
accordance with the laws in force and the instructions given in this use and maintenance manual.
EVERY YEAR, GET THE FUME DISCHARGE SYSTEM, THE FLUE PIPES AND THE "T" FITTINGS AND INSPECTION CAPS
CLEANED IF PRESENT, ALSO THE ELBOWS AND HORIZONTAL SECTIONS!
THE GENERATOR CLEANING FREQUENCY IS INDICATIVE! IT DEPENDS ON THE QUALITY OF THE PELLETS USED AND
ON THE FREQUENCY OF USE.
SOMETIMES THESE OPERATIONS MUST BE PERFORMED MORE OFTEN.

PERIODIC CLEANING UNDER USER'S RESPONSIBILITY

The periodic cleaning operations, as indicated in this use and maintenance manual, must be performed with the utmost care after reading the
instructions, procedures and frequency described in this use and maintenance manual.
CLEANING THE SURFACES AND COATING
Never use abrasive or chemically aggressive cleaning agents for cleaning!
The surfaces must be cleaned when the generator and covering are completely cold. For the maintenance of the surfaces and metal parts,
simply use a cloth dampened with water or water and neutral soap.
Failure to comply with these instruction may damage the surfaces of the generator and cause the invalidation of the warranty.
CLEANING THE CERAMIC GLASS
Never use abrasive or chemically aggressive cleaning agents for cleaning!
The ceramic glass must be cleaned when the glass is completely cold.
To clean the ceramic glass, simply use a dry brush and some damp newspaper dipped in ash. If the glass is very dirty, use a speci c cleaning
agent for ceramic glass. Spray a small amount on a cloth and use it on the ceramic glass. Do not spray the cleaning agent or any other liquid
directly on the glass or seals!
Failure to comply with these instructions may damage the surfaces of the ceramic glass and cause the invalidation of the warranty.
CLEANING THE PELLET TANK
When the tank is completely empty, disconnect the power cable of the generator and remove the residues rst (dust, chippings, etc.) from the
empty tank, and then ll it.
IF THE POWER SUPPLY CABLE IS DAMAGED, IT MUST BE REPLACED BY THE AFTER SALES SERVICE OR BY A SIMILARLY
QUALIFIED PERSON, SO AS TO AVOID AL RISKS.
ENGLISH 77