Skandika Walkingpad Manual Del Usuario página 21

4. Learn to use the WalkingPad
4. Automatic mode instructions (advanced mode)
Automatic mode
This mode is a more challenging and advanced mode.
As described before, the WalkingPad follows the user`s speed
of walking without the need of the remote control.
This mode is recommended for experienced users only.
Short press: stop the WalkingPad.
Mode Switch
Short press: switch to manual mode.
Long press: switch to Standby mode.
11
When entering this
area in automatic
mode, the
WalkingPad will
start or accelerate.
When entering this
area in automatic
mode, the
WalkingPad will
slow down
automatically.
5. Remote Controller Notice
If the remote controller does not respond or if you
have changed the controller, it is necessary to
re-establish communication with the device (pair-
ing).
Remote control pairing:
Restart the WalkingPad, press and hold down the
mode switch button on the remote control immedi-
ately - if you hear a "Beep", this indicates success-
ful pairing.
Note: During pairing, hold remote control close to
the LED display panel of the WalkingPad.
6. Error Warning Light
Error Warning Light on the display panel is off when
Walkingpad works well. When an error occurs, the error
warning light turns on and shows an error code:
E01: Drive communication fault;
E02: Motor abnormalities;
E05: Overcurrent protection;
E06: Motor Protection;
E08: Sensor Fault;
E10: High temperature protection, automatic recovery
after the end of countdown;
E11: Overload protection, please add lubricating oil.
Resume operation automatically after countdown.
12