golmar SV-1370 SII Manual De Instalación página 42

MONITOR DESCRIPTION
F
unction push buttons.
Push button to stablish / finish audio communication or intercom function (only available on
systems with additional monitor, for description and connection see page 44 & 45).
Push button to activate the lock release. During call reception, communication and
autoswitch-on processes, it allows lock release activation. During activation, the picture will
disappear from the monitor screen.
With system in rest ring tone selection monitor, for description see page
Push button for a
door paneI during 40 seconds (in case of systems with two door panels, pushing each time,
the picture and audio will switch from a door panel to the other one), to stablish audio and
video communication with the door panel press
for 80 seconds or until press
Push button to activate the auxiliary device. D
autoswitch-on processes
picture will disappear from the monitor screen.
C
all volume control.
The monitor allows to regulate the call volume from maximum to
minimum value, with the regulator placed in the right side of the
monitor.
C
onfiguration switches
The configuration switches are placed on the monitor base.
Master
*
On installation with one monitor only, set it as master;
Slave
On installations with two monitors, set as slave the monitor that is not connected
IMPORTANT: Modify the configuration switches
On installations with two monitors, set as master the monitor where the door
Factory default.
*
:
utoswitch-on. It allows to visualize the picture and to listen the audio with the
push button monitor again.
, activate the auxiliary device (see page 46). During activation, the
.
on installations with two monitors, set as master the monitor where the door
panel(s) is connected and the other monitor as slave.
the door panel.
panel(s) is connected.
(
push button. The communication will last
uring call reception, communication and
without the power connected.
41
44 ).
M S