Two-Cup Function; Preparing Hot Water - Krups EA829 LATT’ESPRESS Manual De Instrucciones

PREPARATION OF AN ESPRESSO OR A COFFEE
YOUR APPLIANCE HAS BEEN DESIGNED TO WORK EXCLUSIVELY WITH COFFEE BEANS.
When preparing your first coffee, after a long period of non-use or following cleaning or descaling, a little steam and
hot water will come out of the steam nozzle (self-priming).
Splashing or scalding may occur if the coffee outlet is set too high for the size of your cups.
Preparing an espresso
The quantity of water required for an espresso is between 0.7 and 2.4 oz.
Press the button, wait for pre-heating to end and, if you wish, carry out a rinsing operation.
The drinks selection menu appears (14).
Place a cup under the coffee outlet. You can lower or raise the coffee outlet to suit the size of your cup (15).
Select your drink with the rotating dial and confirm by pressing the confirmation dial.
You can set the volume of water at any time with the rotating dial.
To stop the coffee brewing cycle, either press a button or reduce the volume with the rotating dial.
Preparing a coffee
The quantity of water required for a coffee is between 2.7 and 5.4 oz.
Preparing a long coffee
The quantity of water required for a long coffee is between 4.1 and 8.1 oz. The appliance automatically carries out a double cycle,
so do not remove your cup before preparation is finished.
After grinding, the ground coffee is moistened with a little water. A few moments later, the brewing cycle begins.
You can adjust the temperature of your coffee.
DO NOT REMOVE THE TANK BEFORE THE END OF THE CYCLE (around 15 seconds after the coffee has finished
pouring).

Two-cup function

Your appliance enables you to prepare two coffee or espresso recipes for the following three preparations: espresso/strong
espresso/coffee. This function is not available for long coffee drinks. The appliance will automatically run two complete coffee
preparation cycles one after the other. You should therefore ensure that you place the second cup beneath the coffee outlet
immediately after the first cycle has finished.
You have prepared your appliance. The drinks selection menu has appeared (14).
Place a cup under the coffee outlet. You can lower or raise the coffee outlet to suit the size of your cup (15).
Select your drink and confirm by pressing quickly twice on the confirmation button.
A message will indicate that you have requested two cups.
The appliance will automatically run two complete coffee preparation cycles, one after another.
Double cup function (using the double espresso accessory )
(1)
Your appliance enables you to prepare two cups of coffee or espresso for the following three preparations: espresso/strong
espresso/coffee. This function is not available for long coffee drinks.
Make sure you don't take 2 cups after the first cycle.
You have prepared your appliance. The drinks selection menu has appeared.
Place the double cup accessory under the coffee outlet.
Place 2 cups under the accessory's coffee outlets. You can lower or raise the coffee nozzle with the accessory to suit the size
of your cup.
Select your drink and confirm by quickly pressing twice on the OK button.
A message will indicate that you have requested 2 cups.

PREPARING HOT WATER

Install the steam nozzle attachment on the machine. Select the hot water recipe from the drinks selection menu. A message
invites you to place a container beneath the steam nozzle. You can start hot water production by pressing the confirmation button.
To interrupt the hot water function, simply press any button.
If the nozzle is obstructed, unblock it with the needle provided.
The maximum quantity of water per cycle is limited to 10.14 oz.
6