Setting The Program; Setting The Operation Details - Mitsubishi Electric PAC-YT34STA Libro De Instrucciones

4-4-1. Setting the program

(1) Open the PROGRAM SETTING screen.
Press the
MONITOR/SET
flicker at the upper left when this screen is
opened.)
If no operations are made on this screen for
ten minutes, the display will switch to the
Normal screen.
(2) Set the pattern No. displayed at the pattern
No. display will change as shown on the right
each time the
PATTERN
(3) Set the operation No.
The operation No. displayed at the operation No. display will change as shown on the right
each time the
OPERATION
(4) Set the operation time.
1. The clock will advance by five minutes when the CLOCK
held down, the time will advance in five-minute increments or sixty-minute increments.
2. The clock will return by five minutes when the CLOCK
held down, the time will return in five-minute increments or sixty-minute increments.

4-4-2. Setting the operation details

• Set the details to be operated at the time set in the previous section.
• Display only the details to be set.
(1) Set ON/OFF.
The state will change as shown on the right each time the
switch is pressed.
ON/OFF
Set to "No display" if this setting is not required.
(2) Set the operation mode.
The mode will change as shown on the right each time
the switch is pressed.
MODE
Set to "No display" if this setting is not required.
(3) Set the temperature.
1. The temperature will change as shown below each time the TEMP.
temperature will change continuously in 1 increments when the switch is held down.
19
2. The temperature will change as shown below each time the TEMP.
temperature will change continuously in 1 increments when the switch is held down.
28
(4) Set operation prohibit.
The DIP switches must be set to prohibit operations following the schedule with this controller.
Refer to section 8. Setting the functions.
1. Set whether to prohibit or enable operations with the local remote controller.
The state will change as shown below each time the
No display
To not set : Leave the display at "No display".
To set prohibit : Set to "
To enable : Set to "
(This operation is invalid if the SW3 "operation prohibit" is set to "Invalid". (Always a no display state.)
When is displayed, the prohibited "ON/OFF", "MODE" and "TEMP." items will display.)
switch on the PROGRAM MONITOR screen. ("PROGRAM" will
switch is pressed.
switch is pressed.
20
27
(flickers)
PROH.
" (flicker) and set the prohibited item.
" (lit) All items will be permitted when set to "
1 2
01 02
switch is pressed once. When the switch is
switch is pressed once. When the switch is
No display
No display
switch is pressed. The
28
switch is pressed. The
19
switch is pressed.
PROHIBIT
(ON)
PROH.
PERMIT
3 9
03 16
ON OFF
[COOL] [HEAT]
".
13