Rothenberger SUPER-EGO SEGO SD1000200 Manual Del Usuario página 8

GB
Instructions for configuration
A. CONTROL PANEL KEYS:
Key A Menu/O.K. [Menu/O.K.] :
• Programmer configuration
• Selects and activates configuration modes
• Confirms configuration
• Moves raindrop icon
Key B Start [On] :
• Increases digital value
• Adds raindrop icon to selected day of the week
Key C Stop [Off]:
• Decreases digital value
• Deletes raindrop icon from selected day of the
week
B. PROGRAMMER SETTINGS. IMPORTANT:
1- First programme must be started before 15 seconds.
To this end, press Key A once after installing the
battery. If Key A is not pressed before the first 15
seconds, the programmer will be set by default.
Default settings are as follows:
- TIME [TIME] = 12:00
- WATERING TIME [RUN TIME] = 01MIN
- INTERMITTENT CYCLE [MIST CYCLE] = 0
- DURATION OF COMPLETE WATERING CYCLE
[CYCLE TIME] = 1 HR
2- Once the watering programme is being configured,
if data in the paragraph above must be changed,
returning to the previous setting is not possible. In
order for said data to be changed, all setting steps
must be carried out first. When the last setting
is reached, press Key A to automatically save the
settings. Then, start a new setting sequence and
change the required data when the applicable setting
step is reached.
C. FIRST SETTING:
When the battery is installed, the screen displays the
days of the week from Monday (MO) to Sunday (SU)
and the fields [TIME], [START], [RUN TIME], [MIST CYCLE]
and [CYCLE TIME].
(a) A blinking cursor under MO (MONDAY) means
the commencement of the configuration mode
for the days of the week. Press Key B or Key C to
select the day of the current week and press Key
A to save the selection. The cursor stops blinking
and the programme goes automatically to the next
configuration step, TIME [TIME] and then the hour
digits start blinking.
(b) Set [TIME]:
When the time digit blinks, press Key B or C until
the current time is set. Press Key A to save the value.
Then the minutes digit blinks: press Key B or C until
current minutes are set; press Key A to save the value.
Now, the current time is set and the programme goes
automatically to set [START].
(c) Set [START] (0-24 hours)
When digits "12" blink, press Key B or C until the
desired time is set. Then press Key A to save the
value.
Then the minutes digit blinks: press Key B or C until
the desired minutes are set . Then press Key A [Button
A] to save the value.
Now, [START] is set and the programme goes
automatically to set [RUN TIME].
(d) Set [RUN TIME]: Watering time duration can be set
from 1 minute (01 min) to 199minutes.
When digits "00" blink, press Key B or C until the
desired watering minutes are set. Then press Key
A [Button A] to save the value. Now, [RUN TIME] is
set and the programme goes automatically to set
[MIST CYCLE].
(e) Set [MIST CYCLE]: The duration of the mist cycle can
be set from 0 minutes to 19 minutes.
When digit "0" blinks, press Key B or C until the
desired minutes are set. Then press Key A to save the
value. Now, [MIST CYCLE] is set and the programme
goes automatically to set [CYCLE TIME].
8
Key B
Key A
Key C