How To Charge - Powers Fasteners Trak-It Tool TI-C4 Manual De Operaciones/Mantenimiento

HOW TO CHARGE

● Charge the Battery at the specified voltage.
WARNING:
Be sure to charge from a 100-240 V AC (for household use) plug socket. Use of the non-
specified voltage not only causes a trouble, but also is dangerous.
● Handle the power cord with care.
Do not use the Charger whose power cord is damaged.
● Use a proper plug socket.
Use of the rickety or slack plug socket causes an accident due to overheat. If this is the case,
use another proper one.
Latch
100-240 V
Green LED
AC Power Adapter
Charger
Battery
Charger
100-240 V
Red LED
AC Power Plug
● Do not try to charge the Battery which has been fully charged. The life of the Battery could be
CAUTION:
shortened.
q If the Battery is used up, remove it from the tool.
Firmly holding the tool body, press the latches on both side of the Battery with your
fingers to remove.
Battery
w Insert the AC adapter's jack into the Charger and plug the power plug into a
plug socket.
The green LED is turned on to inform you of the power-on status.
e Charge the Battery.
1. Set the Battery firmly in the charger.
2. Once it is set in the charger, charging will start automatically. The red LED is turned
on to inform you that charging is under way.
3. The maximum charging time is approx. 150 minutes. The charging time depends on
the temperature, supply voltage or remaining battery capacity. Once charging is fully
completed, the green LED will be illuminated to inform you that charging has been
completed. If the fully charged Battery is set in the charger again, the red LED will be
turned on again, indicating that it is being charged. This is not an abnormality. After a
while, the green LED will be turned on to indicate completion of charging.
r The Illuminated Green LED Indicates completion of charging.
1. Holding down the charger, remove the Battery.
2. Disconnect the AC adapter's power plug from the plug socket.
Now Charging is complete.
15