How To Drive The Pins; Removing The Pin - Powers Fasteners Trak-It Tool TI-C4 Manual De Operaciones/Mantenimiento

Follower Holder
2
1
q Press Contact Arm against the object.
w Pull the Trigger.
Pusher
Pin Stopper
Pin
w Pull the Follower Holder as far to the rear and of the magazine and release it gently.

HOW TO DRIVE THE PINS

Procedure
q Install the Battery and Fuel Cell.
w Press the nose of the Contact Arm against where you want to drive the pins.
The fan motor is activated, the fuel gas is jetted, mixing the fuel with the air.
e Firmly pressing the Contact Arm, pull the Trigger. The pins are driven into the object
by combustion of the fuel.
WARNING:
● Never put your face above the tool. Reaction of the tool may cause an
unexpected injury.
● Never bring your hand or finger close to the discharge outlet.
r The pins are not shot even if the Contact Arm is applied to the object with the Trigger
pulled. Release the Trigger and repeat Step w.
WARNING:
● Prior to starting work, be sure to check whether the tool functions as
mentioned above.
● If the tool is used for a long period of time, it could get hot and burn you.
If any abnormality is found, contact your nearest authorized distributor for
inspection and repairing.
※ The fan keeps running for approx. 10 seconds even after driving the pins.

REMOVING THE PIN

q Put your finger on the Follower, pull it slightly to the rear, and then, let it back gently.
w Set the Magazine vertical and push the Pin Stopper to remove the Pin.
21