Changing The Hook Direction; Replacing The Fuel Cell; Replacing The Battery - Powers Fasteners Trak-It Tool TI-C4 Manual De Operaciones/Mantenimiento

Hook
Hexagon Socket
Head Bolt
Actuator
2
Valve Stem
Fuel Cell
Latch

CHANGING THE HOOK DIRECTION

WARNING:
● Remove the Fuel Cell and Battery.
The Hook can be directed in the two directions. Remove the hexagon socket head bolts
with hexagon wrench, change the direction, and then, put back the bolts to reassemble.

REPLACING THE FUEL CELL

If the Fuel Gas is low, the pins cannot be driven.
WARNING:
● Be sure to release the Trigger.
● Do not press the Contact Arm against the object.
1
q Push up and pull the Actuator to this side to open it.
w Grab the Metering Valve and remove the used Fuel Cell.
e Set the new Fuel Cell.
(See Page 18 for the setting method)

REPLACING THE BATTERY

If the Battery is low, the red LED of the tool will be turned on.
WARNING:
● Be sure to remove the Fuel Cell.
● Release the Trigger.
● Do not press the Contact Arm against the object.
q Firmly holding the grip, press the latches on both sides of the Battery to remove it.
Battery
22