Cequent Performance Products Pro Serie Manual De Instrucciones página 4

INSTALLATION
1. These instructions should be used to mount the Pro Slider. Care and attention to detail will ensure a quick, safe and
quality installation. Check parts against figure 1 to become familiar with kit.
2. Before installing the Pro Slider, leaf spring must be
greased as shown using white lithium grease or
equivalent (see figure 7). For best results, use
aerosol white lithium grease with a spray nozzle
extension. Make sure entire underside of spring is
coated! Repeat this application monthly during use.
3. Before setting the Pro Slider into the bed of the
pickup, attach handle shaft to handle elbow (see
figure 1 on first page). Insert handle assembly
through left hand slide assembly (driver's side of
towing vehicle) and then through the right hand side
slide assembly (see figure 8).
4. Set the Pro Slider into base rails and pin in
position with the Pro Series Slider in the
middle of the tubes (see figure 9).
Pro Slider Upright
Slide Tube
figure 9
30092IN– 10-13-09 D
See figure 10 for
installed clip locations.
PCN12675 ©2006 CEQUENT PERFORMANCE PRODUCTS, INC.
Aerosol white lithium
grease spray with nozzle
extension
figure 7
figure 8
Leaf spring
Reference label
facing driver side.
WARNING:
Pull pin spring clips must
be on the outside of base rail
as shown. Spring clips
installed on the inside of
base rail will not allow Pro –
Series Slider to slide far
enough to lock. Pro Sliders
that are not properly locked
can suddenly move and
cause serious injury or
death.
Printed in XXXXXX
4