Tabla de contenido
Publicidad
Electrical
•
The power cord of this cooler is equipped with a grounding plug which mates with a standard grounding
wall outlet to minimize the possibility of electric shock hazard.
•
If the outlet is a standard 2-prong outlet, it must be replaced with the properly grounded wall outlet. NEVER
USE AN ADAPTER PLUG!
•
Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly
grounded. Check the incoming voltage with a voltmeter.
•
DO NOT USE EXTENSION CORDS. The use of extension cords to connect the cooler will void warranty.
The unit must be close enough to the electrical supply so that extension cords are never used.
•
The cooler should always be plugged into its own dedicated circuit with a voltage rating that matches the
rating plate. This provides the best performance and also prevents overloading wiring circuits which could
become a fire hazard from overheated wires.
•
Never unplug your cooler by pulling on the power cord. Always grip the plug firmly and pull straight out from
the outlet.
•
Repair or replace immediately all power cords that have become frayed or otherwise damaged. Do not use
a power cord that has cracks or abrasion damage along its length or at either of its ends.
•
When removing the cooler away from the wall be careful not to run over or damage the power cord.
•
When the cooler is installed or used,all the packaging (including carton and plastic wrap) should be
removed.
•
Keep the cooler stable to avoid vibration and noise.
•
The cooler should be installed in a place with good ventilation and a space of at least 4" should be allowed
between the surrounding walls and the cabinet wall for air circulation.
•
Unit should be placed far from any heating source to avoid decrease of refrigeration efficiency.
•
Install the cooler in a dry place to prevent rust from forming on the compartment body, which may affect the
electrical insulation.
It is strongly recommended that any servicing be performed by an authorized service representative.
NOTE: Wiring diagram can be referenced by removing the front louvered grill, and looking on the inside
cabinet wall electrical supply so that extension cords are never used.
Operation
START UP
Plug in the cooler and the compressor is ready to operate.
•
Temperature control set at #4 position gives the cooler an approximate temperature of 35°F. Allow unit to
function several hours, completely cooling cabinet before changing the control setting.
•
Excessive tampering with the control could lead to service difficulties. Should it ever become necessary to
replace the temperature control it should be ordered from your dealer or recommended service agent.
•
Good air flow in your cooler is critical. Be careful to load product so that it neither presses against the back
wall nor comes within four (4) inches of the evaporator housing. Refrigerated air off the coil must circulate
8
Publicidad
Tabla de contenido
