Worx Landroid L Manual Original página 16

4. Turn on and test the installation
This is the exciting part where you can turn your Landroid
4.2
Open the keypad window
by pressing the large red
button on the top of your
Landroid
Press and hold down the
Power ON/OFF
until the Landroid L turns on.
®
Input the default PIN 0000
16
Press the key and close
the keypad window: your
EN
Landroid L will now find its
®
way to the charging base.
Watch the Landroid
returns to the charging base
and modify the positioning
of the boundary wire if
necessary. When the
Landroid L successfully
®
returns to the charging base,
this means the installation has
been successfully completed!
Now your Landroid L will start
®
to fully charge.
• If your Landroid
outside its territory, it
will not move and the
Warning
display will indicate
"outside working area"
error. Just move it inside
its territory and repeat
step 4.2.
NOTE: Please refer to the Programming and Troubleshooting Guide for more information.
L.
®
key
L as it
®
L is • If your Landroid
®
inside its territory but
the display says "outside
working area" and the
LED is on, it means you
clamped the boundary
wire ends incorrectly.
Just reverse them.
L on for the first time.
®
4.1
Place your Landroid
®
working area, a few meters from
the back of the charging base.
L is • Your Landroid L should
® ®
always remain switched
on. If you ever need to
turn it off, then make sure
you place it within its
boundary area before you
switch it back on again.
L inside the
• Should your Landroid
stop operating
unexpectedly, just press
the STOP button, open
its keypad window, press
its ON/OFF key to ON,
correct the problems,
press button, shut its
keypad window.
L
®