How To Assemble Your Ceiling Fan - Fanimation PYLON LP8277LBN Manual De Instrucciones

How to Assemble Your Ceiling Fan

1. Remove the hanger ball portion from the downrod/
hanger ball assembly by loosening the set screw in
the hanger ball until the ball falls freely down the
downrod. Remove the pin from the downrod, then
remove the hanger ball. Retain the pin and hanger ball
for reinstallation in Step 7. (Figure 1)
2. Remove the hairpin clip and clevis pin from the
bottom of the downrod. Retain the pin and clip for
reinstallation in Step 5. (Figure 2)
3. Remove the three stabilizer tabs and plastic bag
from the motor. Discard the stabilizer tabs. (Figure 3)
4. Loosen the two set screws and locking nuts in the
downrod support of the motor assembly. Route the
black, white and blue wires through the downrod.
(Figure 4)
5. Thread downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes
in the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Tighten the two set
screws with nuts in the downrod support. (Figure 5)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in the
fan falling.
Downrod
Hanger Ball
Hairpin
Clip
Stabilizer
Tabs
Set Screws (2)
Downrod
Hairpin Clip
7
Pin
Set Screw
Figure 1
Clevis Pin
Figure 2
Motor
Assembly
Figure 3
Black, White and
Blue Wires
Downrod
Figure 4
Set Screws and
Locking Nuts (2)
Clevis Pin
Figure 5