Start Up; Operation - Windsor RRB 360 Manual Del Usuario

Note
Press the emergency-stop button to imme-
diately deactivate all functions and turn the
key switch to the "0" position.
To unload the machine, proceed as follows:
Cut plastic packing belt and remove foil.
Remove the elastic tape fasteners at
the stop points.
Four indicated floor boards of the pallet
are fastened with screws. Unscrew
these boards.
Place the boards on the edge of the pal-
let. Place the boards in such a way that
they lie in front of the four wheels of the
machine. Fasten the boards with
screws.
Slide the four support beams included
in the packaging under the ramp.
Remove the wooden blocks used for ar-
resting the wheels and slide them under
the ramp.
(1) Machine without built-in battery
Loosen immobilizing brake (see "move
sweep machine").
Slide the machine over the prepared
ramp from the pallet.
(2) Machine with built-in battery
Connect battery (see section on Care
and maintenance)
Release emergency-stop button by
turning.
Set main switch to "1".
Press the drive direction switch and
slowly move the machine down from
the ramp.
Set main switch back to "0".
Move the sweep machine
Danger
– Risk of injury! Before releasing the im-
mobilizing brake, the machine must be
secured to prevent it rolling away. After
releasing the emergency brake, the ap-
pliance will roll until a speed of 2.8 mph
(4.5 km/h) is reached. After that, the
electronics will brake the appliance.
– It is prohibited to release the emergen-
cy brake on an incline without using the
stopper.
Remove the brake level from the wheel
and put it in its position.
The immobilizing brake is thus deactivated;
the machine can now be moved.

Start up

General notes
The appliance will brake electrically while
standing still, if one of the following condi-
tions is met.
– Foot was removed from the pedal.
– Operator's seat was left for more than 1
second.
– Key switch was set to "0".
The automatic emergency brake will only
work while the appliance is at a standstill.
Park the sweeper on an even surface.
Remove the key.
Inspection and maintenance work
Check charging status of battery.
Check side brush.
Check roller brush.
Shake off dust filter.
Empty waste container.
Check tyre pressure.
Note
For description, see section on Care and
maintenance.

Operation

Adjusting driver's seat
Pull seat adjustment lever inwards.
Slide seat, release lever and lock in
place.
Check that the seat is properly locked in
position by attempting to move it back-
wards and forwards.
Check charging status of battery
– Indicator lamp glows green
Battery is charged (100...40%).
– Indicator lamp glows yellow
Battery is discharged to 40 ... 20%.
– Indicator lamp blinks red
Battery is almost discharged. The sweep-
ing mode will be shortly switched off auto-
matically.
– Indicator lamp glows red
Battery is discharged. The sweeping mode
will be terminated automatically (the
sweeping aggregates cannot be taken into
operation until the battery is charged).
Drive the machine directly to the charg-
ing station; avoid any steep gradients in
the process.
Charge battery.
Check immobilizing brake
Danger
Danger of accident. The immobilizing brake
must always be checked first on an even
surface before starting the machine.
Take the seating position.
Release emergency-stop button by
turning.
Set main switch to "1".
Activate the travel direction switch (for-
ward/reverse).
Gently depress drive pedal.
You must hear the brake being re-
leased. The machine must roll slightly
on a plane surface. When the pedal is
released, the brake falls in in an audible
manner. Switch off the machine and call
the aftersales service if the above-men-
tioned events do not occur.
Storage area
Note
The max. load of the storage area is
44.1 lbs (20 kg).
Fasten the load through appropriate
fasteners at the 4 eyelets.
Emergency-stop button
– The appliance has an emergency OFF
switch. If this switch is pressed, the ap-
pliance will stop abruptly and the auto-
matic emergency brake will be
activated.
– In order to restart the appliance, first un-
lock the emergency OFF switch, then
turn the key switch on and off.
Programme selection
1 Driving
Driving to the Place of Use.
2 Sweeping with sweep roller
Roller brush is lowered. The roller brush
and the side brush will rotate.
3 Sweeping using roller brush and side
brushes
Roller brush and side brushes are low-
ered.
Turning on the Machine
Note
The machine is equipped with a seat con-
tact switch When you quit the driver seat,
the machine comes to a halt after a delay of
approx. 1.5 seconds and the activated
sweep function is switched off.
Sit on the driver's seat.
11
English