Windsor RRB 360 Manual Del Usuario página 14

Note
Observe the manufacturer's recommenda-
tions. The journey may be resumed provid-
ing that the directions supplied by the
product manufacturer have been observed.
The tyre/wheel change should nonetheless
be carried out as soon as possible.
Raise slightly the waste container on
the appropriate side and pull it out.
Position vehicle jack at the appropriate
mounting point for the front or rear
wheel.
Raise machine using vehicle jack.
Remove the hexagonal screw (rear
wheel only).
Remove wheel.
Mount spare wheel.
Attach the hexagonal screw (rear wheel
only).
Lower machine using vehicle jack.
Push in the waste container and lock it.
Note
Use a suitable commercially available vehi-
cle jack.
Checking the sweeping mirror of the
side-brushes
Check tyre pressure.
The side-brushes lift up.
Drive sweeper on to a smooth, even
surface covered with a visible layer of
dust or chalk.
Lower side-brushes and allow them to
briefly rotate.
The side-brushes lift up.
Drive machine backwards.
Park the sweeper on an even surface.
Check sweeping mirror.
The width of the sweeping track should lie
between 1.6-2.0 in (40-50 mm).
Note
The side brush floating mounting adjusts
the sweeping track as the bristles wear
down. The side brush must be replaced if it
becomes too worn.
Replacing side brush
Park the sweeper on an even surface.
14
English
Set programme switch to step 1 (driv-
ing). Side brushes lift up.
Turn main key to "0" and remove it.
Loosen 3 fastening screws on the un-
derside.
Clip side brush on to driver and screw
on.
Checking roller brush
Park the sweeper on an even surface.
Set programme switch to step 1 (driv-
ing). Roller brush is raised.
Turn main key to "0" and remove it.
Secure the machine with wheel
chock(s) to prevent it from rolling away.
Remove belts or cords from roller
brush.
Replacing roller brush
Replacement is due if a visible deteriora-
tion in sweeping performance caused by
bristle wear is evident.
Park the sweeper on an even surface.
Set programme switch to step 1 (driv-
ing). Roller brush is raised.
Turn main key to "0" and remove it.
Secure the machine with wheel
chock(s) to prevent it from rolling away.
Raise slightly the waste container on
the left side and pull it out.
Loosen the fastening screw on the left
side-panel.
Remove side panel.
Unhook pull spring.
A Fastening screw of the under-pressure
can
B Fastening nut of the bulk waste flap
C Screw of the roller brush crank
Unscrew the fastening screws of the
vacuum socket and release the lever.
Turn the fastening nut of the bulk waste
flap and unhook the bulk waste flap.
Unscrew and withdraw bolt on the roller
brush swinging arm.
Push the roller brush cover backwards
and remove it.
Pull out roller brush.
Installation position of roller brush in direc-
tion of travel
Push new roller brush into the roller
brush housing and onto the drive pin.
Note
When installing the new roller brush, en-
sure correct positioning of the bristle as-
sembly.
Position roller brush cover.
Fit the fastening screws and nuts.
Hook the draw spring in.
Screw on side panel.
Push in the waste containers on both
the sides and lock them.
Check the sweeping mirror of the
sweeping roller
Set programme switch to step 1 (driv-
ing). The side brush and roller brush are
raised.
Drive sweeper on to a smooth, even
surface covered with a visible layer of
dust or chalk.
Set programme switch to step 2. Roller
brush is lowered. Slightly press down
on the drive pedal and allow the sweep
brush to briefly rotate.
Raise roller brush.