Gira Cube 120 Manual De Instrucciones página 18

Wall installation
 Fasten the mounting plate to the wall
(Fig. 1).
 Pierce the rubber grommet in the angled
mounting bracket and insert the lines.
Attach the angled mounting bracket to the
mounting plate (Fig. 2) and press it closed
(Fig. 3).
 Attach the sensor unit to the angled
mounting bracket (Fig. 4) and connect it
according to the wiring diagram (Fig. 15 to
17).
 Push the sensor unit up into the angled
mounting bracket and snap it in place
(Fig. 5).
 Slide the cover over the sensor unit and
place the cover on the angled mounting
bracket (Fig. 6).
Ceiling mounting
 Fasten the mounting plate to the ceiling
(Fig. 8).
 Pierce the rubber grommet in the angled
mounting bracket and insert the lines.
Attach the angled mounting bracket to the
mounting plate (Fig. 2) and press it closed
(Fig. 3).
 Attach the sensor unit to the angled
mounting bracket (Fig. 11) and connect it
according to the wiring diagram (Fig. 15 to
17).
 Push the sensor unit up into the angled
mounting bracket and snap it in place
(Fig. 12).
 Break out the drainage opening in the cov-
er (Fig. 13).
 Slide the cover over the sensor unit and
place the cover on the rear of the angled
mounting bracket (Fig. 13).
18
I
Note on parallel mounting
(Fig. 17)
- Do not exceed the maximum con-
nected load of a motion detector.
- Connect all motion detectors to
the same phase.
- Up to 10 motion detectors can be
connected in parallel.
- The cable length between two
motion detectors must not exceed
50 m.
LED function
Normal operation
Test operation
Continuously ON/
OFF
Teach-in / day mode
Remote control
Restrict detection field
The detection field can be restricted using the
covering panel, e.g. to suppress sources of
interference.
 Slide the cover down (Fig. 21).
 Loosen the lens screws on the sensor unit
(Fig. 22).
 Push the lens in the direction of the angled
mounting bracket (Fig. 23).
 Remove the lens (Fig. 24).
 If necessary, cut out the covering panel
with scissors along the marked lines
(Fig. 25).
 Place the covering panel in the lens and
mount the lens again in reverse order.
LED off
LED lights up during
movement
LED lights up
The LED flashes five
times. Teach-in or
day mode is acti-
vated.
LED flashes