Technical Data - Gira Cube 120 Manual De Instrucciones

Technical data

Rated voltage:
Connected load
HV LED lamps:
Light bulbs:
Fluorescent lamps,
uncompensated:
Fluorescent lamps,
parallel-compensated:
Fluorescent lamps,
row-compensated:
Setting controller
Brightness value:
Delay time:
Protection level:
Connection cross sec-
tion:
Ambient temperature:
Dimensions WxHxD
in mm
without lens
with lens
Troubleshooting
Motion detector does not switch on
Cause 1: Ambient brightness is higher than
the brightness threshold set.
Increase brightness threshold with twilight
setting controller.
Cause 2: Lamp defective.
Replace the lamp.
Cause 3: Fuse defective.
New fuse, check connection if necessary.
Cause 4: Detection range not set.
Re-adjust it.
Motion detector does not switch off
Cause 1: Continuous movement in the detec-
tion range.
Check the range and readjust or cover if
necessary.
230 V~
(50 / 60 Hz)
typically 200 W
2000 W
1000 VA
(cos φ = 0.5)
500 W (45.6 μF)
900 W
2 to 1000 lx
5 seconds to
15 minutes
IP54
Fig. 20
-25 °C to +55 °C
87 x 87 x 85
87 x 113 x 85
Cause 2: Switched light is within the detec-
tion range and switches on again due to a
change in temperature.
Change or cover range.
Cause 3: Switched light is in continuous ON
operation (LED on).
Deactivate continuous light operation.
Motion detector always switches ON and
OFF
Cause 1: Switched light is in the detection
range.
Change or cover range and increase dis-
tance.
Cause 2: Animals are moving within the
detection range.
Change or cover range.
Motion detector switches on although this
is not desired
Cause 1: Wind moves trees and shrubs in the
detection range.
Restrict detection range.
Cause 2: Detection of cars on the road.
Restrict detection range.
Cause 3: Sunlight falls on the lens.
Attach in a protected manner or change
the range.
Cause 4: Sudden change in temperature due
to weather (wind, rain, snow) or air from fans
or open windows.
Change range, relocate installation loca-
tion.
Cause 5: Anti-glare active.
Manual switching via switch.
No movement within the set delay time +
60 seconds (glare protection).
Cause 6: Motion detector near WLAN or
other radio sources.
Install at a distance of least 2 m from the
radio source
LED flashes 1 × every 15 seconds
Cause: Too large load connected.
Reduce load or use relay.
19