Frame Bracket Installation - Cequent Performance Products 66559 Manual Del Propietário

FRAME BRACKET INSTALLATION:

Item No. Qty.
1 4
2
2
4
3
2
4
5
2
1. Use the tape measure to locate a point between 27-32"
along the A-Frame from the center of the coupler. Mark
this location with a pencil on both sides of the A-Frame
(See Fig. 3)
2. Insert a 3-1/2" long 5/8" bolt (1) through the large hole in
the T-Bar and single hole in the Clamping Bar.
3. Secure with a 5/8" lock nut (2) and hand tighten.
4. Slide the T-Bar and Clamping Bar over the frame where
the mark is located from step 1. The T-Bar must be
located on the outside of the A-Frame with the large hole
facing outward (See Fig. 4). Allow 1" of clearance on
either side of the T-Bar.
5. Insert a second 5/8" bolt from the inside through a conical
washer and the Clamping Bar and thread into the T-Bar.
Use the highest holes not obstructed by the bottom of the
frame (See Fig. 4).
Note: 1-1/2" wide frames require the 2-3/4" long 5/8"
bolts (5) to fasten the bottom of the T-Bar and
Clamping Bar.
6. Snug the 5/8" nuts and confirm that the brackets are
installed correctly (See Fig. 5).
7. Repeat steps 1-6 for the other side of the A-Frame.
8. Snug all 5/8" hardware (do not torque at this time).
66559N REV H
Description
Hex Bolt 5/8"-11 x 3-1/2" GR5
5/8"-11 Lock Nut
5/8" Conical Washer
Hex Bolt 5/8"-11 x 1-1/4" GR5
Hex Bolt (For 1.5" Wide Frames)
5/8"-11 x 2-3/4" GR5
PCN9354 ©2016 CEQUENT
Correct
™
PERFORMANCE PRODUCTS, INC
Fig. 3
Fig. 4
Space
Space
Incorrect Incorrect
Fig. 5
Space
Incorrect
5