OZ Lifting Products ELECTRIC Serie Manual Del Operador página 8

I. TEST AND OPERATIONAL CHECKS:
On completion of installation, but before the hoist is put into regular service, the following procedure
should be carried out:
1. Record the hoist's Code, Lot and Serial Number from the name plate on the hoist.
2. Check that the hoist is properly installed to either a fixed point or trolley, whichever applies.
3. If hoist is installed on a trolley, ensure that:
- The trolley is properly installed on the beam.
- The stops for the trolley are correctly positioned and securely installed on the beam.
4. Isolate the power supply.
5. Check that all mechanical and electrical joints and connections are tight and secure.
6. Check that all nuts, bolts and split pins (cotter pins) are securely fastened.
7. Confirm proper operation:
- Before operating read and become familiar with this manual.
-Before operating check to ensure that the hoist (and trolley) meet the Inspection, Testing
and Maintenance requirements of ANSI!ASME B30.16.
-Before operating check that nothing will interfere with the full range of the hoist's
(and trolley's) operation.
8. Switch on the power supply.
9. Run lightly with no load, throughout the full extent of the hoist and check that the operation is
smooth at all times.
10. Check the operation of the hoist brake, run under light load and full load conditions.
Check supply voltage before everyday use. If the voltage varies more than 10% of the rated
CAUTION
value, electrical devices may not function normally.
Confirm the adequacy of the rated capacity for all slings, chains, wire ropes and all other
WARNING
lifting attachments before use. Inspect all load suspension members for damage prior to
use and replace or repair all damaged parts.
WARNING Verify and correct all chain irregularities prior to operating the hoist.
J. UNPACKING:
Once package has been opened, carefully inspect the hoist frame, hooks, chain and control station for
damage that may have occurred during shipment.
Operating a unit with obvious external damage may cause load to drop and could result in
WARNING personal injury and/or property damage.
To avoid injury: Carefully check unit for external damage prior to installation.
Make sure to check that the power supply to which the hoist is to be connected matches the information
shown on the identification plate located on the bottom of the hoist.
BEFORE USING THE HOIST, FILL IN THE INFORMATION BELOW:
Model No.: _______________________________________
Serial No.: _______________________________________
Purchase Date: ___________________________________
EN pg.8