Mechanical Installation; Electrical Installation - Tuthill FILL-RITE FR102PHU Manual Del Usaurio

Mechanical Installation

1. Install the pump (if not included) securely to the top of the fuel tank
per the instructions included with the pump.
2. Install mounting plate or pedestal as applicable for your installation.
3. Place dispenser on mounting plate or pedestal; using the 4 – 1/2 x
13 screws, and grommet washers, attach the dispenser securely to
the mounting surface through the 4 holes located in bottom of the
dispenser cabinet base (figure 1).
4. Installations must include an Emergency Shut-Off Valve (not
supplied) to the dispenser inlet. Position valve so it can be rigidly
mounted and is not dependent on the dispenser for support.
5. Carefully measure and install pipe between the pump and
Emergency Shut Off Valve. The pipe is not intended to support
the pump or the dispenser in any manner.
NOTE: Dimensional drawings to aid in installation are located on page 4.
CAUTION! Threaded pipe joints and connections should be sealed with the appropriate
sealant or sealant tape to minimize the possibility of leaks.

Electrical Installation

WARNING! Overall dispenser installation and electrical wiring should be performed ONLY
by a licensed electrician and service personnel in compliance with local, state, and national
electrical code NEC/ANSI/NFPA 70, NFPA30, NFPA 30A, and NFPA 395 as appropriate to
the intended use of the dispenser. Threaded rigid conduit, sealed fittings, and conductor seal
should be used. The pump must be properly grounded. Improper installation or use of this
dispenser can result in serious bodily injury, or death!
CAUTION! All electrical appliances should operate at the rated nameplate voltage. Power
should be supplied to this dispenser from a dedicated circuit breaker appropriately sized to
handle the pump being used with the dispenser. No other equipment should be powered
by this circuit. Wiring must be of sufficient size to carry the correct current for the pump.
Voltage drop will vary with distance to pump and size of wire; refer to the National Electrical
Code (NEC), or local codes, for voltage drop compensation to be sure you are using the
correct size wire for your application.
Model
FR102PHU
FR902DPU
FR302DPU
Refer to the section of this manual pertaining to your particular model for detailed wiring information.
All wiring connections must be made inside the explosion proof junction box built into every dispenser
cabinet. Use extreme caution when wiring in this junction box to maintain the integrity of the
explosion proof design. The 300 Series pump inside the FR302DPUU cabinet has a wiring junction
box on the pump for the pump wiring (see diagram page 12 and 13).
Cabinet Dispenser Electrical Rating
Voltage (VAC)
125
250
115/230
Frequency (Hz)
60
60
60/50
5
Current (A)
20
20
9.8/4.9/11.4/5.7
Figure 1
Power (HP)
1
2
3/4