Briteq BT-150LS Manual De Instrucciones página 6

ENGLISH
3. BUTTONS
4. DMX INPUT/OUTPUT: used for DMX512 linking. Use good quality 3pin XLR M/F balanced cable to link
the units together.
5. WIRED REMOTE CONTROL INPUT: Used to connect a simple CA-8 hand controller while the unit is
used in standalone or master/slave mode.
6. WIRELESS REMOTE CONTROL INPUT: Used to connect RF-8 wireless controller while the unit is used
in standalone or master/slave mode.
7. MAINS FUSE: protects the internal electronics, not the power in/outlet! Replace the fuse always by one
with the same value.
8. MAINS INPUT & OUTPUT: IEC sockets: connect the supplied mains cable to the input, the output can
be used to link power to a next unit.
MAIN MENU:
 To select any of the functions, press the MENU button several times until the required one is shown on the
display or use the DOWN and UP buttons to browse the menu.
 Select the function with the ENTER button (the display blinks).
 Use DOWN and UP buttons to change the mode or value.
 Once the required mode or value is selected, press the ENTER button to confirm.
 Then press the MENU button for about 2 seconds to exit the programming mode and to store the new
settings in the memory.
DMX Address
Used to set the starting address in a DMX setup.
 Press the MENU button until "DMX Address" is shown on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP buttons to change the DMX512 address.
 Once the correct address shows on the display, press the ENTER button to save it.
To go back to the main menu without any change press the MENU button shortly.
To exit the programming mode and to store the new settings in the memory: press the MENU button for
about 2 seconds.
Channel mode
Used to set the desired channel setup mode.
 Press the MENU button until "Channel mode" is shown on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP buttons to choose 14Ch or 15Ch mode.
 Once the desired channel setup mode shows on the display, press the ENTER button to save it.
To go back to the main menu without any change press the MENU button shortly.
To exit the programming mode and to store the new settings in the memory: press the MENU button for
about 2 seconds.
Show Mode
Choose the Show mode when the unit will be used in standalone or master/slave mode.
 Press the MENU button until "Show Mode" appears on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP buttons to select one of the available shows:
 Show 1: Fixture is placed on the floor. Tilt movement angle 210°.
 Show 2: Fixture is fixed under ceiling. Tilt movement angle 90°.
 Show 3: Fixture is placed on a podium, in front of the audience. The spot is always projecting to
the audience's direction; i.e. in front of the stage. Pan movement angle (left to right to left): 160°. Tilt
movement angle: 90° (60° above horizon; 30° below horizon.)
 Show 4: Fixture is fixed under ceiling. The spot is mainly projecting in front of the stage. Pan
movement angle (left to right to left):160°. Tilt movement angle: 90° (vertically, front 75°; back 15°)
 Once the right mode shows on the display, press the ENTER button to save it.
BRITEQ
®
MENU To select the programming functions
DOWN To go backward in the selected functions
UP To go forward in the selected functions
ENTER To confirm the selected functions
4/69
OPERATION MANUAL
BT-150LS