Setting The Clock To Current Time And Day; Setting Zone Run Time - Irritrol 500 Serie Guía De Instalación Y Operación

STEP 1: Setting The Clock To Current Time And Day
The controller's clock features a 12-hour format — 12:00 p.m. represents noon
and 12:00 a.m. represents midnight.
When the power is first applied, the controller automatically displays SUN
(Sunday) and a time of 4:00 p.m. See example below.
• To set the correct hour:
Press the CLOCK key followed by the SET TIME key. The hour digit(s) and
will flash. Press the
PM
displayed.
Note: Once a function key, such as CLOCK or SET TIME has been
pressed, another key must be pressed within 15 seconds to prevent the dis-
play from automatically returning to the time/day mode.
• To set the correct minute:
Press the SET TIME key again. The minute digits will flash. Press the
or key until the appropriate minute is displayed.
• To set the correct day of the week:
Press the SET TIME key again. The current day of the week will begin to
flash (SUN is the default). Press the
the week is displayed.
STEP 2: Setting The Zone Run Time:
Each zone can be set with a run time duration from 2 minutes to 3 hours.
• To set the zone run time:
Move the sliding switch for each zone to align with the desired watering run
time indicator. (Do not place the switch between indicated run times.)
PROGRAMMING STEPS
SUN
TIME OF DAY
or key until the appropriate hour (a.m. or p.m.) is
13
PM
or key until the appropriate day of