Carrera 16441011 Manual De Instrucciones página 27

3. Connect the mains plug to a Socket. The display shows speed setting "1" by
default.
4. Use the speed control
shown on the display.
NOTE: The more liquid the food, the lower the speed; the more solid the food,
the higher the speed.
5. Hold the stick blender and the container with the food to be blended.
6. Immerse the stick blender in the food to be blended.
NOTES:
In order to keep the food from spurting out, only switch on the stick blender
after it has been immersed in the food.
When switching on the stick blender, hold it at a slight angle so that it cannot
attach itself to the bottom of the container.
3
7. Press button if you want to blend with a previously selected speed
setting. Press button
setting). Release the button if you want to complete the blending process.
NOTES:
If the timer has been activated, the blending time will be shown on the display
(see chapter section "Timer"). The blending times stated in the charts must not be
exceeded.
Never leave the appliance switched on longer than necessary for preparing
the foods.
In order to avoid overheating, do not operate the appliance under continuous
load for a prolonged period of time.
Foods should preferably be processed in smaller quantities and with repeated
blending times of a few seconds only.
Only remove the stick blender from the food after it has been switched off.
8. Pull the mains plug and remove the blender shaft from the motor block in
order to clean it.
Stick blender – Blending times and preparationg
Food Maximum
quantity
Carrots 266 g
Water 400 g
1
to select the desired speed setting (1–6); will be
4
if you want to blend at the highest speed (turbo
Maximum
blending time
60 sec
Preparation Speed
1.5 cm II
/
GB 27