General Safety Instructions; Intended Use - Siemens 1FK7 01. Manual De Instrucciones

1

General safety instructions

The synchronous motors correspond to the harmonized standards of the EN 60034 and
EN 60204-1 and there is conformity with the 73/23/EEC Low Voltage Directive.
Standard motors conform to UL regulations. The rating plates of these motors are marked
with UR.
Ensure that your end product conforms to all currently valid legal requirements.
Follow the compulsory national, local and installation-specific regulations.
EU Manufacturer`s Declaration According to Article 4 Paragraph 2 of the
EU Directive 98/37/EU:
- The products supplied fulfill the requirements of standard EN 60204-1.
- The products supplied are intended exclusively for installation in a machine.
- Commissioning is prohibited it has until been established that the end product conforms
with the Directive 98/37/EU.
- All safety instructions in the associated product documentation must be observed and
given to the end user for his/her information.
- This declaration contains no condition and durability guarantee to § 443 BGB.
The operating manual applies in conjunction with the SIEMENS Configuration Manual, see
table.
Configuration Manual
Code Titel
/PFK7S/ Synchronous motors 1FK7 for SINAMICS
/PFK7/ Synchronous motors 1FK7 for SIMODRIVE/MASTERDRIVES
All safety instructions must be observed during the transport, storage, assembly,
disassembly and operation of the synchronous motors!
Failure to observe the instructions can lead to serious personal injuries or property damage.
The motors' rotors contain permanent magnets with high magnetic flux densities
which exert strong attractive forces on ferromagnetic bodies.
People fitted with a heart pacemaker are at risk in the vicinity of a disassembled rotor.
Data stored on electronic data media may be destroyed.
It is forbidden to use the motors in areas at risk of explosion, unless expressly stated.
Thermal hazards
The temperatures of motor surfaces can reach more than 100 °C (212 °F).
Do not touch hot surfaces!
Temperature-sensitive components (electric lines, electronic components) must not touch
hot surfaces.
Overheating in the motors may destroy the windings and bearings, and demagnetize the
permanent magnets.
Only operate the motors with effective temperature control.

Intended use

Usage for the intended purpose includes observing all the specifications in the operating
manual and the Configuration Manual "Synchronous motors".
Siemens AG
ENGLISH
610.40 700.21
Order No.
6SN1197-0AD16-0BP1
6SN1197-0AD06-0BP1
9