Operation Instruction; Charging Indicator - Hyper Tough HT19-401-003-04 Manual Del Operador

BEFORE PUTTING INTO OPERATION
1. CHARGING YOUR BATTERY PACK
FOR CHARGER HT19-401-003-14
IMPORTANT NOTES FOR CHARGING BATTERY
The battery in your new tool is not charged when it leaves the plant. Therefore it must be full charged before
using the first time.
NOTE: If the battery pack is very hot you must remove your battery pack from the charger and allow your
battery pack to cool first to ambient temperature and then recharging can be started.
To prevent damage to the Battery Pack, when charge runs out, please charge the battery to reach full or no less
than half charge before storage.
If the tool will not be used for long periods of time, charge the battery every 3-6 months.
CHARGING PROCEDURE (SEE FIG. F1)
1) Plug the charger into an appropriate outlet. The light will be green.
2) Slide the battery pack into the charger, the light will turn to red to indicate the charging process has started.
3) When charging is completed, the light will turn to green. The pack is now fully charged, unplug the charger
and remove the battery pack.
WARNING:
When battery charge runs out after continuously use or exposure to direct sunlight or heat, allow
time for the tool to cool down before re-charging to achieve the full charge.

CHARGING INDICATOR

Light
Red on
Green on
FOR CHARGER ACG318W1U
CHARGING PROCEDURES (SEE FIG. F2)
Connect the battery charger to the power supply and the indicator light should turn to green. Then, slide the
charger base on the battery pack to make connections and the indicator light will turn red to show that the
charging has started. It will remain red until the battery is fully charged. When charging is completed, unplug
the charger and remove the battery pack.
CHARGING INDICATOR
Light
Red on
Green on
FOR CHARGER HT19-401-003-13
IMPORTANT NOTES FOR CHARGING BATTERY
The battery charger supplied is matched to the Li-ion battery installed in the machine. Do not use another
battery charger.
The Li-ion battery is protected against deep discharging. When the battery is empty, the machine is switched
off by means of a protective circuit: The tool holder no longer rotates.
In a warm environment or after heavy use, the battery pack may become too hot to permit charging. Allow
time for the battery to cool down before recharging.
When the battery pack is charged for the first time and after prolonged storage, the battery pack will accept a

OPERATION INSTRUCTION

14
Status
Charging
Fully Charged
Status
Charging
Fully Charged