Hyper Tough HT19-401-003-04 Manual Del Operador página 15

100% charge after several charge and discharge cycles.
CHARGING PROCEDURE (SEE FIG. F3)
1) Plug the charger into an appropriate outlet. The light will be green.
2) Slide the battery pack into the charger, the light will turn to red to indicate the charging process has started.
3) When charging is completed, the light will turn to green. The pack is now fully charged, unplug the charger
and remove the battery pack.
WARNING: When battery charge runs out after continuously use or exposure to direct sunlight or heat, allow
time for the tool to cool down before re-charging to achieve the full charge.
CHARGING INDICATOR
Light
Red on
Green on
NOTE: The accessories of battery charger (HT19-401-003-13 /ACG318W1U) and battery pack (ABP118T7/HT19-
401-003-17 ) illustrated or described are not included in HT19-401-003-04 delivery.
2. TO REMOVE OR INSTALL BATTERY PACK (See Fig. G)
Depress the Battery Pack Release Button to remove the Battery Pack from your tool. After recharging, insert
the Battery Pack into the battery port. A simple push and slight pressure will be sufficient until a click is heard.
Check to see if the battery is fully secured.
NOTE: When removing the battery pack, hold it firmly to avoid dropping and injury.
OPERATION
1. SWITCHING ON AND OFF (See Fig. H)
Attention: Check the battery pack before using your cordless tool. Only use the battery pack listed in the
accessories section.
For switching on the tool, press the lock-out button, then fully press the on/off switch and hold in this position.
the lock-out button can now be released.
For switching off, release the on/off switch.
2. CUTTING
1) Installing the battery pack into the machine.
2) Make sure section of log to be cut is not laying on the ground. This will keep the chain from touching the
ground as it cuts through the log. Touching the ground while the Chain is moving is dangerous and will
dull the Chain.
3) Use both hands to grip saw. Always use left hand to grip Front Handle and right hand to grip Rear Handle.
Use a firm grip. Thumbs and fingers must wrap around saw handles. (See Fig. I)
4) Make sure your footing is firm. Keep feet-shoulder width apart. Distribute your weight evenly on both feet.
5) When ready to make a cut, push the lock-off button completely in with the right thumb and squeeze the
trigger. This will turn saw on. Releasing the trigger will turn the saw off. Make sure the saw is running at full
speed before starting a cut.
6) When starting a cut, slowly place moving chain against the wood. The wood should be as close to the saw
body as possible. Hold saw firmly in place to avoid possible bouncing or skating (sideways movement) of
saw.
7) Guide the saw using light pressure and do not put excessive force on the saw, letting the saw do its work.
The motor will overload and can burn out. It will do the job better and safer at the rate for which it was
intended.
8) Remove the saw from a cut with the saw running at full speed. Stop the saw by releasing the On/off
Switch. Make sure the chain has stopped before setting the saw down.
ON/OFF flash
15
Status
Charging
Fully Charged