Preparing Other Drinks - Krups EA84 Serie Manual De Instrucciones

IFU_KR_EA84_NAFTA_EA84 25/10/13 11:01 Page15
Preparing an espresso
The appliance grinds the beans, tamp the ground coffee and performs percolation.
It is possible to adjust the volume of coffee in preparation using the - and + buttons.
You can stop the preparation at any time by pressing "STOP" button. Caution, pressing
stop causes a resetting phase that can last up to 30 seconds. This is normal.
When a cycle is interrupted, the appliance does not stop immediately, the appliance will
finish its cycle but the preparation will be cancelled.
!
Caution! : Automatic rinsing of the coffee nozzle
Depending on the type of recipes prepared, the appliance may carry out an automatic
rinsing operation when it is switched off.
The cycle lasts only a few seconds and will stop automatically.

Preparing other drinks:

Important: we recommend that you use very fresh, very cold pasteurised milk, recently
!
opened. Unpasteurised milk does not produce the best results.
Important: After using the steam functions, the steam nozzle can remain hot; we
!
recommend that you wait a few moments before touching and cleaning it.
For drinks with frothed milk or hot water, the drip tray has been specially designed to allow
you to fit a large cup under the steam nozzle or the super cappuccino accessory, once the
magnetised box has been removed (R). The cup is ideally positioned to collect the frothed
milk or the hot water produced by the nozzle or the super cappuccino accessory. Further-
more, you can use the box as storage for the super cappuccino accessory.
RECIPES MADE WITH MILK
Recipes made with the steam nozzle (depending on model): check before each preparation
to make sure that it is locked properly by turning it completely to the right. Fig. 11.
The steam froths the milk. As steam production requires high temperatures, the appliance
has an additional preheating phase.
When the screen displays the drink selection menu, press the "steam" button.
The screen indicates that the appliance is preheating and a message appears asking you
to place a container under the steam nozzle. You can start the steam production by pressing
the "OK" button.
MILK FROTH
Pour milk into your milk container. Only fill half way. Immerse the steam nozzle into the milk.
Fig. 12.
Press the steam button and follow the on-screen instructions.
To achieve a good result:
Stage 1: While holding the milk container, immerse the steam nozzle into the milk (about
0.8 inch) and wait for it to start frothing.
Stage 2: Raise the container slightly (about 0.4 inch). Never immerse the steam nozzle
completely.
Stage 3: Lower the container gradually as the foam increases.
Press any button to stop the steam function. Caution, the cycle does not stop immediately.
15