Astralpool Victoria Dual Speed Manual Del Usuario página 6

DIGITAL TIMER TIME SETTING
After initializing, the time will have to be set. To do so, the season, day of the week and time must be set.
TO SET THE SEASON (HIGH OR LOW)
Firstly, the PROG/OK button must be held pressed for about 4 seconds, in order to enter into the programming function.
Then, the season logo could be chosen by pressing the DAY/SEANSON button.
To confirm the selection, the PROG/OK button will have to be pressed.
TO SET THE DAY OF THE WEEK
The button PROG/OK will have to be hold. In the same time, when pressing the DAY/SEASON button the day of the
week will change.
To confirm the selection, the PROG/OK button will have to be pressed.
TO SET THE HOUR
The button PROG/OK will have to be hold. In the same time, when pressing the TIME button the time shown will change.
Leave the TIME button when the time shown is correct. For a fine adjust, leave the TIME button and press it shortly.
When pressing continuously the TIME button, the time shown in the screen will change faster.
To confirm the selection, the PROG/OK button will have to be pressed.
DIGITAL TIMER PROGRAMMING
The digital timer programming is done in 4 different steps: Season, day, hour and programmed speed.
THE PROGRAMMING PROCESS IS SHOWN IN THE FOLLOWING SCHEME:
6
Initial screen
PROG/OK (more than 3 seconds)
Programming: Season
Selection: DAY/SEASON (more than 3 seconds)
PROG/OK (more than 3 seconds)
Programming: Day of week
Selection: DAY/SEASON
Continuar programación: PROG/OK
Programming: Hour
Selection: TIMER
Continuar programación: PROG/OK
Programming: Speed
Selection: STOP / ECO / TURBO
Follow programming: PROG/OK (next hour
Exit:: PROG/OK (more than 3 seconds)
Exit:: PROG/OK (more than 3 seconds)
Exit:: PROG/OK (more than 3 seconds)
Day reset: ERASE (more than 5 seconds)
Exit:: PROG/OK (more than 3 seconds)
Day reset: ERASE (more than 5 seconds)
)
ASTRALPOOL - Victoria Dual Speed