Advanced Operation - KlipXtreme Zound36O KWS-015 Manual De Usario

4.2 Turning your speakers on or o
• To turn the speakers on, press and hold the Power
each unit.
• Press and hold the power button again for 2 seconds to turn a single unit off
when unpaired. However, if the two are linked, then both will be powered off
simultaneously upon pressing this button on the left (master) unit.
• Every time the speakers are switched on and off, a tone will sound to indicate in
what state each unit currently is.

5. Advanced operation

5.1 Pairing the twin speakers
The speakers are intended to be linked together so as to experience True Wireless
Stereo sound via Bluetooth .
®
• First make sure that the speakers do not have an active Bluetooth
connection with a mobile device.
• Power on both speakers and then press the Link
them to initiate the automatic pairing mode between the two units.
This process may take between 30-60 seconds to complete.
• When the LED blinks on one speaker while the Link
becomes solid on the other, it means that the TWS connection has
been successfully established.
• The unit with the indicator on, will become the master (left) speaker. The unit
with the lit indicator, will become the slave (right) speaker.
• Playback functions remain accessible in either unit. Phone commands, however,
button for 2 seconds on
®
button on one of
indicator
they are available only through the master (left) speaker.
5.2 Bluetooth® mode of operation
1. The blinking LED from previous section indicates that the speaker has
entered into the pairing mode.
2. Place your mobile device and the speakers not more than 2 meters away from
each other.
3. Set your mobile device to discover the wireless speaker. Once the KWS-015 is
displayed in the newly detected device list, select it by pressing Yes or OK to
accept. If you have a lower Bluetooth
passkey 0000 (4 zeros).
4. When pairing is successful, the speaker will confirm with an audible tone and a
solid LED indication.
5. If after 60 seconds the pairing process fails, please repeat steps 1 through 4 as
described above.
6. The speakers will automatically go into standby mode after 10 minutes of
inactivity to save battery life.
7. The automatic re-pairing feature will allow the speakers to be reconnected to
your mobile device after being switched back on or when placed again within
wireless range.
Note: When the two speakers are paired/linked, you can power off using the
master (left) unit. When you power it back on, turn on the master (left) first
followed by the slave (right) and wait about 10-15 seconds for the auto link/pair.
You will know it is successfully linked again when you see both, the master (left)
speaker with the LED and the Link LED on the Slave (right) illuminated.
version, you maybe prompted to enter the
®