Installation And Setup - GN Netcom Jabra GO 6430 Guia De Inicio Rapido

INSTALLATION AND SETUP

step 1: Connect power to the travel charger
Connect the mini-USB port on the Travel Charger to
one of the following power sources:
- any USB port on a powered-on computer via the
supplied mini-USB-to-USB cable (charge time is longer
when connected to a PC)
- a mains power socket via the supplied mains power
adapter
- a car's cigarette lighter via the car charge adapter
(optional accessory)
step 2: insert the Jabra go™ headset into the travel
charger
See the figure below:
The headset LED shows the current charge status: red
(low; <10%), yellow (medium; 10 – <100%) or green
when fully charged. Allow the headset to charge until
it lights yellow or green before continuing (usually the
headset ships with a partial charge).
Us
step 3: adjust the headset wearing-style
The headset is delivered already attached to the
ear hook wearing style, shown below alongside the
headband (available as an optional accessory).
Slide the hook's attachment up or down in the hinge-
like mount on the headset as shown, until the headset
fits most comfortably to your ear.
When you put on the headset, always ensure that the
microphone is positioned as close to your mouth as
possible. This maximizes the noise-cancelling effect
of its microphone and ensures that your voice comes
through loud and clear.
For further details on attaching/detaching wearing
styles, refer to the procedures in the full user manual
on the CD-ROM supplied with your headset.
step 4: Connect the headset to your mobile phone
1. If your headset is currently turned on, turn it off —
press and hold its multifunction button for about
4 seconds.
Its LED gives four quick flashes and then turns off.
2. Put your (powered-off ) headset into Bluetooth
pairing mode — press and hold its multifunction
button for about 4 seconds.
1 mm